TY - JOUR N2 - The results of model investigations of the influence of the blowing process selected parameters on the distribution of the compaction of the core made by the blowing method, are presented in the hereby paper. These parameters were: shooting pressure, shooting hole diameter, amount and distribution of deaerating holes. Investigations were performed using the horizontal core box of the cuboidal cavity and the same core box into which inner inserts were introduced. These inserts were dividing the primary volume into three sectors differing in their direction, introduction conditions and the character of the core sand flow. As the compaction measure the apparent sand density was assumed. The density was determined in five measuring points in case of uniform cores, and in three measuring points in case of cores obtained in the core box with three separated sectors. The apparent density of the compacted core sand in the core box cavity was determined on the basis of the measurements of masses and volumes of samples cut-out from the determined core places by means of the measuring probe. Investigations were performed at three values of the working pressure equal 0.4, 0.5 and 0.6MPa for two diameters of the shooting hole: 10 and 20 mm. During tests the core box deaeration, controlled by an activisation of the determined number of deaerating vents placed in the core box, was also subjected to changes. L1 - http://journals.pan.pl/Content/106804/PDF/AFE%202_2018_35.pdf L2 - http://journals.pan.pl/Content/106804 PY - 2018 IS - No 2 KW - core shooting KW - blowing process KW - core sand KW - core box A1 - Dańko, R. PB - The Katowice Branch of the Polish Academy of Sciences VL - vol.18 DA - 2018 T1 - Compaction of Cores Made by Blowing Methods – Model Investigations UR - http://journals.pan.pl/dlibra/publication/edition/106804 T2 - Archives of Foundry Engineering ER -