Applied sciences

Archives of Acoustics


Archives of Acoustics | 2013 | No 2 |


Abstract Active Noise Control (ANC) of noise transmitted through a vibrating plate causes many problems not observed in classical ANC using loudspeakers. They are mainly due to vibrations of a not ideally clamped plate and use of nonlinear actuators, like MFC patches. In case of noise transmission though a plate, nonlinerities exist in both primary and secondary paths. Existence of nonlinerities in the system may degrade performance of a linear feedforward control system usually used for ANC. The performance degradation is especially visible for simple deterministic noise, such as tonal noise, where very high reduction is expected. Linear feedforward systems in such cases are unable to cope with higher harmonics generated by the nonlinearities. Moreover, nonlinearities, if not properly tackled with, may cause divergence of an adaptive control system. In this paper a feedforward ANC system reducing sound transmitted through a vibrating plate is presented. The ANC system uses nonlinear control filters to suppress negative effects of nonlinearies in the system. Filtered-error LMS algorithm, found more suitable than usually used Filtered-reference LMS algorithm, is employed for updating parameters of the nonlinear filters. The control system is experimentally verified and obtained results are discussed.
Go to article


Abstract The hazard assessment of ultrasonic noise impact on human body at workplaces presents an open problem; it is not satisfactorily solved comparing the fund of knowledge and standard regulations established for the case of audible noise. Some research carried on in the Central Institute of Labour Protection - National Research Institute, Poland, are essential for elaboration reliable procedures for the assessment of ultrasonic noise hazard and they have to bring to modernization and creation the corresponding standards in this field. In the presentation, some problems related to measurement procedures applied as well as to the interpretation of results essential for hazard assessment of ultrasonic noise impact on human body will be considered; in particular such cases where some procedures elaborated for audible noise assessment are being transferred to apply in the ultrasonic range without taking fully into account some specific aspects of the high frequency components of the noise.
Go to article


Abstract Faculty of Natural and Technical Sciences and Faculty of Medical Sciences starting from December 2012, launched joint study in order to investigate personal noise exposure and associated health effects in general school teachers population, starting from kindergartens up to high schools in Stip, Macedonia. In order to determine workplace associated noise exposure and associated health effects in this specific profession, a full shift noise exposure of 40 teachers from 1 kindergarten, 2 primary and 2 high schools were measured in real conditions using noise dosimeters. A-weighted equivalent-continuous sound pressure levels (LAeq) of each teacher were recorded during single activities (classes). Normalized 8-hours exposure, termed the noise exposure level (Lex;8 h) was also computed. Daily noise dose is another descriptor for noise exposure that was determined as a measure of the total sound energy to which workers have been exposed, as a result of working in the varying noise levels. Health effects were assessed trough a full scale epidemiological study which included 231 teachers from the same schools. Specific questionnaire was used to extract information about subject’s perception on occupational noise exposure, as well as theirs occupational and medical history.
Go to article

Editorial office

Editorial Board
Andrzej Nowicki (Institute of Fundamental Technological Research PAN, Warszawa)
Deputy Editor-in-Chief
Barbara Gambin (Institute of Fundamental Technological Research PAN, Warszawa)
Associate Editors
Genaral linear acoustics and physical acoustics
• Wojciech P. Rdzanek (University of Rzeszów, Rzeszów)
• Anna Snakowska (AGH University of Science and Technology, Kraków)
Architectural acoustics
• Tadeusz Kamisiński (AGH University of Science and Technology, Kraków)
Musical acoustics and psychological acoustics
• Andrzej Miśkiewicz (The Fryderyk Chopin University of Music, Warszawa)
• Anna Preis (Adam Mickiewicz University, Poznań)
Underwater acoustics and nonlinear acoustics
• Grażyna Grelowska (Gdańsk University of Technology, Gdańsk)
Speech, Computational acoustics and signal processing
• Ryszard Gubrynowicz (Polish-Japanese Institute of Information Technology, Warszawa)
Ultrasonics, transducers and instrumentation
• Krzysztof Opieliński (Wrocław University of Technology, Wrocław)
• Jan Żera (Warsaw University of Technology, Warszawa)
Noise control and environmental acoustics
• Jan Adamczyk (AGH University of Science and Technology, Kraków)
• Mirosław Meissner (Institute of Fundamental Technological Research PAN, Warszawa)
• Janusz Kompała (Central Mining Institute, Katowice)
• Izabela Ewa Mika


Archives of Acoustics
Institute of Fundamental Technological Research
5b Pawińskiego Str.,
02-106 Warszawa, Poland
Phone: (48) (22) 826 12 81 ext. 206
Fax: (48) (22) 826 98 15

Support Contact
Paweł Witkowski

Instructions for authors

Author Guidelines
• Manuscripts intended for publication in Archives of Acoustics should be submitted in pdf format by an on-line procedure.
• Manuscript should be original, and should not be submitted either previously or simultaneously elsewhere, neither in whole, nor in part.
• Submitted papers must be written in good English and proofread by a native speaker.
• Basically, the papers should not exceed 40 000 typographic signs.
• Postal addresses, affiliations and email addresses for each author are required.
• Detailed information see Article Requirements.
• Manuscript should be accompanied by a cover letter containing the information:
o why the paper is submitted to ARCHIVES OF ACOUSTICS,
o suggestion on the field of acoustics related to the topic of the submitted paper,
o the statement that the manuscript is original, the submission has not been previously published, nor was sent to another journal for consideration,
o 3–5 names of suggested reviewers together with their affiliations, full postal and e-mail addresses; at least 3 suggested reviewers should be affiliated with other scientific institutions than the affiliations of the authors,
o author’s suggestion to classification of the paper as the research paper, review paper or technical note.

Article Requirements
1. At submission time only a PDF file is required. After acceptance, authors must submit all source material (see information about Figures). Authors can use their preferred manuscript-preparation software. The journal itself is produced in LaTeX, so accepted articles will be converted to LaTeX at production time.
2. The title of the paper should be as short as possible.
3. Full names and surnames should be given.
4. The full postal address of each affiliation, including the country name should be provided. Affiliations should contain the full postal address, as well as an e-mail address of one author designated as corresponding author.
5. The text should be preceded by a concise abstract (less than 200 words).
6. Keywords should be given.
7. The formulae to be numbered are those referred to in the paper, as well as the final formulae.
8. All notations should be written very distinctly.
9. References in the text (author(s) and year of publication) are to be cited between parentheses.
Items appearing in the reference list should be complete, including surname and the initials of the first name of the author, the full title of the paper/book in English followed by the information on the original paper language. In case of a book, the publisher's name, the place and year of publication should be given. In case of a periodical, the full title of the periodical, consecutive volume number, current issue number, pages, and year of publication should be given. All references in the bibliography should be cited in the text, and arranged in alphabetical order by authors' last name.
For more information on references see
10. Figures must be of publication quality. Each figure should be saved in separate file and captioned and numbered so that it can float. After acceptance, Authors will need to submit the original source files for all photos, diagrams and graphs in manuscript.
For diagrams and graphs vector EPS or vector PDF files are the most useful. Make sure that what you're saving is vector graphics and not a bitmap. Please also include the original data for any plots. This is particularly important if you are unable to save Excel-generated plots in vector format. Saving them as bitmaps is not useful; please send the Excel (.xls) spreadsheets instead.
Photographs should be high-quality – with resolution no lower than 300 dpi.
Pack all figure files into a single archive (zip, tar, rar or other format) and then upload on the magazine web site.

This page uses 'cookies'. Learn more