Details

Title

The Analysis of Force Parameters in Drawing Process of High Carbon Steel Wires in Conventional and Hydrodynamic Dies

Journal title

Archives of Metallurgy and Materials

Yearbook

2017

Numer

No 4

Publication authors

Keywords

Metals and Alloys

Divisions of PAS

Nauki Techniczne

Abstract

<jats:title>Abstract</jats:title><jats:p>The paper analyzes force parameters in the process of multistage drawing of steel wires in conventional and hydrodynamic dies. The drawing process of the wire rod with a diameter of 5.5 mm for wires with a diameter of 1.70 mm was performed in 12 drafts with the usage of the multistage drawbench Koch KGT with the speed range of 5-25 m/s.</jats:p><jats:p>Modern software of multistage drawbenches allows direct reading of many parameters during the drawing process, including drawing power. The force and drawing stress in each drafts were determined relying on experimental measurements. A complement to the research was a theoretical analysis of the drawing process. The results of the theoretical studies were compared to those obtained by experiment.</jats:p><jats:p>The significant impact of the drawing speed on the force parameters of the drawing process in conventional and hydrodynamic dies was demonstrated. Depending on the real conditions of the drawing, ie. temperature, friction and lubrication, enhancing the drawing speed can result in both an increase and a decrease in drawing stress.</jats:p>

Publisher

Institute of Metallurgy and Materials Science of Polish Academy of Sciences ; Commitee on Metallurgy of Polish Academy of Sciences

Date

2017

Identifier

ISSN 1733-3490

DOI

10.1515/amm-2017-0329

×