The work contains a description of a developed experimental and theoretical method of modeling of solid waste combustion in a device equipped with a moving grate and capability to optimize the work of waste incineration plant. Implementation of this issue was based on results of experimental studies made on a laboratory scale boiler. This was possible by defining and testing indicators of quantitative assessment of combustion such as: reaction front rate, ignition rate, the rate of combusted mass loss and the heat release rate. These indicators as measurable "criteria indicators" allow transfer of parameters from a laboratory-scale unit, working in the transient regime into an industrial full scale grate device working continuously in stable determined conditions. This allows for wide optimization possibilities in the operation of a waste incineration plant, in particular the combustion chamber, equipped with a moving grate system.
Studies on biocompatibility of AISI 316LVM steel indicate the need to eliminate the nickel from the surface and replace it with other elements of improved biocompatibility. Therefore, in the presented work selected physicochemical and mechanical properties of the diffusive nitrocarburized layer formed by plasma potential by means of an active screen made of the Fe-Cr-Ni were studied. In the paper we present results of microstructure and phase composition of the layers, roughness, and surface wettability, potentiodynamic pitting corrosion resistance, penetration of ions into the solution as well as mechanical properties. The studies were conducted for the samples of both mechanically polished and nitrocarburized surfaces, after sterilization, and exposure to the Ringer’s solution. Deposition of the nitrocarburized layer increased the contact angle, surface roughness, surface hardness, and corrosion resistance with respect to the polished surfaces. The nitrocarburized layer is a barrier against the ions release into the solution and sterilization and exposure to Ringer solution. The obtained results showed beneficial increase of both mechanical and electrochemical properties of the deposited layer, and thus the applicability of the proposed method of surface treatment of the 316LVM steel for short-term implants after sterylization.