Characteristics of the microstructure of corrosion-resistant cast 24Cr-5Ni-2.5Mo duplex steel after introduction of 0.98, 1.67 and 4.3% Si were described. Based on the test results it has been found that silicon addition introduced to the corrosion-resistant cast two-phase duplex steel significantly reduces austenite content in the alloy matrix. Increasing silicon content in the test alloy to 4.3% has resulted, in addition to the elimination of austenite, also in the precipitation of Si-containing intermetallic phases at the grain boundaries and inside the grains. The precipitates were characterized by varying content of Cr and Mo, indicating the presence in the structure of more than one type of the brittle phase characteristic for this group of materials. The simulation using Thermo-Calc software has confirmed the presence of ferrite in all tested alloys. In the material containing 4.3% Si, the Cr and Si enriched precipitates, such as G phase and Cr3Si were additionally observed to occur.
The aim of our study was to determine the influence of L-carnitine (L-CAR) on the cellular parameters of hen erythrocytes during a 48 hour exposure to L-CAR at concentrations of 25, 50 and 100 mg/mL in nutrient-deficient medium. Cell morphology, haemolysis, caspase 3/7 activity and glucose uptake (GU) were determined. The results showed a lower percentage of apoptotic cells and decreased haemolysis of erythrocytes treated for 48 hours at all the concentrations of L-CAR. The amino acid at 50 mg/mL inhibited the activity of proapoptotic caspase 3/7; however, it increased GU. In contrast, caspase 3/7 level was increased but GU was decreased in erythrocytes treated with 100 mg/mL of L-CAR when compared to the control. It may be hypothesized that reduction of apoptotic changes in hen erythrocytes may result from increased GU.
A computational approach to analysis of wave propagation in plane stress problems is presented. The initial-boundary value problem is spatially approximated by the multi-node C⁰ displacement-based isoparametric quadrilateral finite elements. To integrate the element matrices the multi-node Gauss-Legendre-Lobatto quadrature rule is employed. The temporal discretization is carried out by the Newmark type algorithm reformulated to accommodate the structure of local element matrices. Numerical simulations are conducted for a T-shaped steel panel for different cases of initial excitation. For diagnostic purposes, the uniformly distributed loads subjected to an edge of the T-joint are found to be the most appropriate for design of ultrasonic devices for monitoring the structural element integrity.
This paper addresses the problem of road safety regarding barrier placement as relative to the curb. A short summary of existing regulations is presented. Numerical simulations using the explicit finite element system Ls-Dyna are shown. In the analysis, variable distance between the barrier and the curb is assumed. The obtained result reveals that the distance has little impact on the working width of the barrier.