Several conclusions and recommendations concerning sediment trap geometry, the technique of their deployment and interpretation of measurements results are described in this paper. Only cylindrical sediment traps are able to cope with the diverse and dynamic environment of glaciated fjords. The relation between different trap parameters shows the optimal proportion of cylinder diameter as being between 6 and 10 cm and ratio length/diameter not less than 7/1. During the peak of the melting season in Kongsfjorden (Spitsbergen) the rate of sedimentation of total matter reaches over 900 g m2 d1 and the velocity of brackish water current can reach 80 cm s1 on the surface. Owing to the high productivity of Arctic fiords and large concentration of suspended mineral matter it is possible to collect of large samples in a short time, therefore prevention of sediment traps by swimmers is not necessary.
The Silurian Pelplin Formation is a part of a thick, mud-prone distal fill of the Caledonian foredeep, which stretches along the western margin of the East European Craton. The Pelplin Formation consists of organic carbon- rich mudstones that have recently been the target of intensive investigations, as they represent a potential source of shale gas. The Pelplin mudstones host numerous calcite concretions containing authigenic pyrite and barite. Mineralogical and petrographic examination (XRD, optical microscopy, cathodoluminoscopy, SEM-EDS) and stable isotope analyses (δ13Corg, δ13C and δ18O of carbonates, δ34S and δ18O of barite) were carried out in order to understand the diagenetic conditions that led to precipitation of this carbonate-sulfide-sulfate paragenesis and to see if the concretions can enhance the understanding of sedimentary settings in the Baltic and Lublin basins during the Silurian. Barite formed during early diagenesis before and during the concretionary growth due to a deceleration of sedimentation during increased primary productivity. The main stages of concretionary growth took place in yet uncompacted sediments shortly after their deposition in the sulfate reduction zone. This precompactional cementation led to preferential preservation of original sedimentary structures, faunal assemblages and early- diagenetic barite, which have been mostly lost in the surrounding mudstones during burial. These components allowed for the reconstruction of important paleoenvironmental conditions in the Baltic and Lublin basins, such as depth, proximity to the detrital orogenic source and marine primary productivity. Investigation of the concretions also enabled estimation of the magnitude of mechanical compaction of the mudstones and calculation of original sedimentation rates. Moreover, it showed that biogenic methane was produced at an early-diagenetic stage, whereas thermogenic hydrocarbons migrated through the Pelplin Formation during deep burial.