The iron ore mine owned by the state concern of Luossavaara – Kiirunavaara AB-LKAB state concern has several mining skip shaft hoists for drawing iron ore. Despite using modern systems to secure the travel of these hoists in line with the Swedish regulations, units intended for the emergency breaking of vessels must be used in the so-called free travel paths in the tower and in the shaft sump. The paper discusses the main requirements that, in accordance with the Swedish regulations as regards the operational use of mining shaft hoists, must be met by devices of this type and a solution was proposed for a structure design of the braking unit for the mining shaft hoist installed in the B-1 shaft in the Kiruna mine. The frictional braking system in the form of moving bumping beams was decided to be used in the said hoist, developed in the Cable Transport Department in the University of Science and Technology in Krakow. The action of moving bumping beams consists in these beams, placed at the beginning of free travel paths, not only braking the rushing hoist vessels but also (with the integrated units for vessel capture) performing the function of grips. They secure the vessels against falling down into the shaft after the finished braking process. The advantage of such a solution is that the structural elements: the guiding shank of the tower, the head of the vessel and the bumping beams, transfer many times lower values of dynamic forces at the time of the strike of the vessel against the moving bumping beams when compared with dynamic forces arising at the time of the hit of the vessel against the fixed bumping beams. In the process of designing moving bumping beams, braking simulation is an important stage conducted with a computer program developed in KTL AGH. This program enables the modelling of load-bearing and balance ropes as flexible elements with elastic and suppressing properties. The results of these simulations, especially in the scope of the achieved braking deceleration of the vessels, the values of braking distances and forces in the load-bearing ropes are crucial in confirming the correctness of the assumed concept of the emergency braking system. The braking units in the form of moving bumping beams have been executed by the Polish company Coal-Bud Sp. z o.o. and are now being integrated in the tower and in the shaft sump of the B-1 shaft of the Kiruna mine in Sweden.
Modern regulations concerning railway bridges are based on the approach of structural dynamics, which is described in PN-EN standards. This paper presents the results of theoretical dynamic analysis of the HSLM-A train set loading on the structure of a pre-stressed concrete arch bridge - the first railway bridge of its type which was built in Poland (completed in 1959). The recommendations of PN-EN have been followed and modal analysis was carried out to define the sensitivity of the structure to chosen eigenforms. Additionally the paper presents a course of calculations and the conclusions obtained from the analysis of displacements, accelerations, and bending moments induced in the structure through a simulated passage of a high-speed train in the context of the requirements of PN-EN Standards. The conclusions from the current calculations can be used for dynamic analysis of bridges of similar structural solutions.
The study deals with stability and dynamic problems in bar structures using a probabilistic approach. Structural design parameters are defined as deterministic values and also as random variables, which are not correlated. The criterion of structural failure is expressed by the condition of non-exceeding the admissible load multiplier and condition of non-exceeding the admissible vertical displacement. The Hasofer-Lind index was used as a reliability measure. The primary research tool is the FORM method. In order to verify the correctness of the calculations Monte Carlo and Importance Sampling methods were used. The sensitivity of the reliability index to the random variables was defined. The limit state function is not an explicit function of random variables. This dependence was determined using a numerical procedure, e.g. the finite element methods. The paper aims to present the communication between the STAND reliability analysis program and the KRATA and MES3D external FE programs.