The ways of the improvement of the method for the determination of steel losses in the electrical devices of basic types are substantiated. The method is refined by taking into account the magnetic system properties at high saturation. The presence of the interrelation between the special features of the domain structure movement and the shape of the hysteresis loop is proved for laminated cores. It enabled the explanation of the causes for the abnormally high values of the losses in the steel and the atypical shapes of the hysteresis loops at its high saturation. The empiric dependence for the determination of steel losses is obtained. It provides for the high convergence of the calculated and experimental data at the actual degree of saturation and can be used in the direct-current operation of the analyzed devices.
Magnetic properties of Fe nanowire arrays (NWs) electrodeposited in anodic alumina membranes have been studied. The influence of nanowire geometry (length, pore diameter) and an external magnetic field applied during electrodeposition process on the magnetic properties of nanowire arrays was investigated. With the use of the X-ray diffraction analysis the structure of iron wires was determined. The iron wires have the regular Body Centered Cubic structure. Magnetic measurements show that shape anisotropy aligns the preferential magnetization axis along the wire axis. It was found that the application of an external magnetic field in a parallel direction to the sample surface induces magnetic anisotropy with an easy axis of magnetization following the nanowire axis. The dependence of the height of Fe wires on the electrodeposition time was determined.
Reinforced concrete composite slab consists of a thin prefabricated slab in which span reinforcement is located and of concrete joined with the slab, with such concrete being laid on site. The existence of a joint of two concretes in such floors is interpreted as introducing a contact layer into a monolithic slab. In the paper parameters of two models are estimated. The first is a model of a contact layer and the second is a model of a composite slab with a single degree of freedom. The models consider that the contact has elastic properties and inelastic properties causing energy dissipation. Experimental investigations are discussed further based on which the parameters values of the contact layer model were determined. Delamination was experienced for the slabs characterised by low contact layer stiffness after applying a maximum load. In addition, the strains of a contact layer having low stiffness are accompanied by lower energy dissipation than of a layer with high stiffness. The smaller stiffness of composite floors, as compared to monolithic floors, occurs as a consequence of the existence of a joint. Such decrease for a composite slab is interpreted in the model with a single degree of freedom as the serial connection of stiffness of a monolithic slab and an element considering the existence of a contact layer. The stiffness of an element considering the existence of a contact layer decreases along with a load, and the elements corresponding to the higher stiffness of the contact layer are characterised by higher energy dissipation. The aforementioned results of the investigations confirm the assumptions of the contact layer model and a composite slab model with a single degree of freedom. The findings made represent a basis for establishing a method of evaluating the condition of a joint in composite slabs according to statistical investigations.
The Goss texture is a characteristic feature of grain-oriented transformer steel sheets. Generator sheets, which are produced as non-oriented steel sheets, should have isotropic features. However, measurement results of generator sheets, confirmed by crystallographic studies, indicate that these sheets are characterized by certain, quite significant anisotropy. The first purpose of this paper is to present the influence of textures of generator and transformer steel sheets on their magnetization characteristics. The second aim is to propose a method which takes into account the sheet textures in the calculations of magnetization curves. In calculations of magnetization processes in electrical steel sheets, models in which the plane of a sheet sample is divided into an assumed number of specified directions are used. To each direction a certain hysteresis loop, the so-called direction hysteresis, is assigned. The parameters of these direction hystereses depend, among other things, on the texture type in these steel sheets. This paper discusses the method which calculates the parameters of these direction hystereses taking into account the given sheet texture. The proposed method gives a possibility of determining the magnetization characteristics for any direction of the field intensity changes.