This paper presents a method based on the use of fuzzy logic for the rapid selection of optimal induction sintering parameters. The prepared fuzzy controller uses expert knowledge developed from the results of induction sintering tests of Ti-5Al-5Mo-5V-3Cr alloy green compacts produced from a mixture of elemental powders. The analysis of the influence of the applied sintering parameters on the material characteristics was based on the evaluation of the microstructure state and the measurement of the relative density of the samples after sintering. In this way, a universal tool for estimating the sintering parameters of titanium powder-based green compacts was obtained. It was shown that with the help of fuzzy logic it is possible to analyze the influence of the parameters of the manufacturing process of metal powder materials on the quality of the obtained products.

The paper presents an approach based on the use of the fuzzy logic method as a tool for quick estimation of favorable parameters of hot plastic working of selected alloy and for the identification of those combinations of parameters that should be avoided. The idea and basic principles of operation of fuzzy controllers for the selection of thermo-mechanical parameters of hot metal forming were presented. The most important information necessary for a quick analysis based on knowledge engineering has been compiled. An example of the fuzzy controller using the information obtained based on plastometric test data and the results of observation of the microstructure state of deformed samples at various temperature and strain rate variants is presented. For the tested alloy, it was shown that the analysis of the parameters of their plastic processing using the fuzzy logic method, based on properly formulated expert knowledge, leads to obtaining satisfactory results. Thus, it was confirmed that fuzzy logic can be successfully used as a tool for quick estimation of correct or unfavorable thermal and mechanical combinations of hot forging processes.