Complaints and awareness about environmental low-frequency (LF) noise and infrasound (IS) have increased in recent years, but knowledge about perceptual mechanisms is limited. To evaluate the use of the brain’s frequency-following response (FFR) as an objective correlate of individual sensitivity to IS and LF, we recorded the FFR to monaurally presented IS (11 Hz) and LF (38 Hz) tones over a 30-phon range for 11 subjects. It was found that 11-Hz FFRs were often significant already at ~0 phon, steeply grew to 20 phon, and saturated above. In contrast, the 38-Hz FFR growth was relatively shallow and continued to 60 phon. Furthermore, at the same loudness level (30 phon), the 11-Hz FFR strength was significantly larger (4.5 dB) than for 38 Hz, possibly reflecting a higher phase synchronization across the auditory pathway. Overall, unexpected inter-individual variability as well as qualitative differences between the measured FFR growth functions and typical loudness growth make interpretation of the FFR as objective correlate of IS and LF sensitivity difficult.

A new extraction process suitable for treating refractory CuCo2S4 under atmospheric pressure acidic leaching conditions was investigated. The effect of variables such as oxidant species, liquid-to-solid ratio, leaching time, oxidizing agent and mineral quality ratio, H2SO4 concentration, temperature and sodium chloride concentration on the extraction efficiency of Co, Cu and Fe from CuCo2S4 were investigated. Under optimal conditions including P80-P90 of the sample was d < 0.0074 mm, stirring speed of 400 rpm, leaching time of 8 h with sodium chlorate (NaClO3) and mineral quality ratio of 0.5, 2 mol/L H2SO4, liquid-to-solid ratio of 7, leaching temperature of 90°C and 4 mol/L sodium chloride. The leaching efficiency of Co, Cu, and Fe were nearly 97.08%, 100%, and 92.45%, respectively. Furthermore, the contents of cobalt and copper in leaching residue were all less than 0.4 wt.%, which satisfies the requirements of industrial production.

Polymer composite materials based on the Moplen HP400R polypropylene matrix with a filler from walnut shell flour with 30, 40 and 50% content and 200-315 µm and 315-443 µm fraction were produced by the injection method. The effect of filler content was analysed on the processing properties of the composites such as: MFR Melt Flow Rate and the MVR Melt Volume-flow Rate, as well as the temperature of the filler flour decomposition using the TGA thermogravimetric analysis method. The following was also determined: density, hardness, tensile strength and stiffness modulus of elasticity of the materials in question. The obtained composite material was characterised by low density, which increased with the rising filler content. It was found that the applied natural filler has increased the hardness and stiffness modulus of the composite and decreased the tensile strength.