The two-dimensional distribution of gas-solid flow parameters is a great research significance to reflect the actual situation in industry. The commonly used method is the ultrasonic tomography method, in which multiple probes are arranged at various angles, or the measurement device is rotated as that in medicine, but in most industrial situations, it is impossible to install probes at all angles or rotate the measured pipe. The backscattering method, however, uses only one transducer to both transmit and receive signals, and the twodimensional information is obtained by only rotating the transducer. Ultrasound attenuates greatly in the air, and the attenuation changes with frequency. Therefore, COMSOL is used to study the reflection of particles with different radii in the air to ultrasound with various frequencies. It is found that the backscattering equivalent voltage is the largest when the product of ultrasonic frequency and particle radius is about 27.78 Hz �� m, and the particle concentration of 30% causes the strongest backscattering. The simulated results are in good agreement with the Faran backscattering model, which can provide references for selecting the appropriate frequency and obtaining the concentration when measuring gas-solid two-phase flow with the ultrasonic backscattering method.

The article presents the assumptions, characteristics and description of the implementation of a pilot system for on-line monitoring of partial discharges in heads of the high-voltage cable lines. The main purpose of the implementation was to increase the reliability of cable line heads by equipping them with a system of continuous assessment of technical condition with direct transmission of measurement data and alarms to the SCADA system. In order to achieve the assumed goal, unconventional methods for measuring partial discharges were used, the application of which does not require disconnecting the line from the voltage. The implementation was carried out on an active 110 kV high voltage cable line in the area of activity of one of the Distribution System Operators.

Results of the studies for determining fractions of organic contaminants in a pretreated petrochemical wastewater flowing into a pilot Aerated Submerged Fixed-Bed Biofilm Reactor (ASFBBR) are presented and discussed. The method of chemical oxygen demand (COD) fractionation consisted of physical tests and biological assays. It was found that the main part of the total COD in the petrochemical, pretreated wastewater was soluble organic substance with average value of 57.6%. The fractions of particulate and colloidal organic matter were found to be 31.8% and 10.6%, respectively. About 40% of COD in the influent was determined as readily biodegradable COD. The inert fraction of the soluble organic matter in the petrochemical wastewater constituted about 60% of the influent colloidal and soluble COD. Determination of degree of hydrolysis (DH) of the colloidal fraction of COD was also included in the paper. The estimated value of DH was about 62%. Values of the assayed COD fractions were compared with the same parameters obtained for municipal wastewater by other authors.