This paper presents the results of research into the cross wedge rolling (CWR) process of axle forgings. The presented results concern the parallel rolling process with two wedges. The use of two parallel wedges is aimed at shortening the tool length (increasing productivity) and reducing the values of wedge opening angles and increasing the forming angles, so that the condition 0.04 ≤ tgαtgβ ≤ 0.08 is maintained to guarantee the highest quality forgings. The article analyses the influence of the design of the double wedge tool on the geometric correctness of the forgings obtained, the value of the failure criterion and the force parameters of the process. The results obtained show that the use of multi wedge tools improves rolling conditions by increasing productivity and reducing the tendency of the material to crack with appropriately selected tool parameters.

The world in 21st century is facing the problem of growing energy consumption while the supply of fossil fuels is being reduced. This resulted in the development of research into the use of renewable energy sources and development of new technologies for energy production. In Polish conditions the development of agricultural biogas plants finds its legitimacy in the document developed by the Ministry titled "Trends in agricultural biogas plants in Poland in 2010-2020”. The purpose of this study was to investigate the influence of the weather conditions and the degree of nitrogen fertilisation on yield of reed canary grass (Phalaris Arundinacea L.) and to determine their susceptibility to anaerobic digestion, and usefulness of the production of biogas. Carried out experiments showed that increasing nitrogen fertilisation (from 40 to 120 kg N/ha) linearly increased canary grass green biomass yield from 32 to 46.3 t/ha. However, the highest biogas yield 126 m3/ha was obtained when 80 kg N/ha was applied.