This paper presents an experimental study on chicken egg white solution ultrafiltration, where membrane fouling has been the main point of concern. Separation process has been performed with a 150 kDa tubular ceramic TiO2/Al2O3 membrane. The operating parameters have been set as follows: transmembrane pressure 105–310 kPa, cross-flow velocity 2.73–4.55 m/s, pH 5 and constant temperature of 293 K. Resistance-in-series model has been used to calculate total resistance and its components. The experimental data have been described with four pore blocking models (complete blocking, intermediate blocking, standard blocking and cake filtration). The results obtained show that the dominant fouling mechanism is represented by cake filtration model.
Carbon dioxide (CO2) is a compound responsible for the greenhouse effect. One of the methods of CO2 capture from the gas stream is adsorption process. In this paper, the adsorption equilibrium isotherms of CO2 on zeolite 13X were measured at different temperatures (293.15 K, 303.15 K, 313.15 K, 323.15 K, 333.15 K, 348.15 K, 373.15 K, 393.15 K) and under pressures up to 2 MPa. These data were obtained using an Intelligent Gravimetric Analyzer (IGA-002, Hiden Isochema, UK). Selected multitemperature adsorption isotherm equations, namely Toth, Langmuir–Freundlich, and, Langmuir were correlated with experimental data.
This paper presents an experimental study on Cochineal Red A dye adsorptive removal by yeast. Batch equilibrium and kinetic tests were conducted in constant temperature of 30 ◦C for the dye’s initial concentration range of 0.02–0.50 g/L (pH = 3 and 10) and 0.02–0.35 g/L (pH = 7:6). The equilibrium was reached after 105–120 min. Yeast demonstrated the adsorption capacity of 10.16 mg/g for acidic environment (pH = 3) and slightly lower values (8.13 mg/g and 8.38 mg/g respectively) for neutral (pH = 7:6) and alkaline environment (pH = 10). The experimental equilibrium results were fitted with Langmuir, Freundlich, Sips and Toth isotherm models. Most of them (Freundlich model being the exception) were proven sufficient for the experimental data correlation. The adsorption kinetic studies showed that the pseudo-second order model fits better the experimental data than the pseudo-first- order model. Results achieved from intra-particle diffusion model indicate that powdered yeast are a nonporous adsorbent. The percentage of solution discoloration reached a maximum value of 75% at pH = 3 for an initial dye concentration of 0.02 g/L.
The cyclic Electrothermal Temperature Swing Adsorption (ETSA) process in a fixed-bed column with Supersorbon K40 activated carbon (AC) was applied to remove propan-2-ol (IPA) from air. The bed was electrothermally regenerated using direct resistive heating method. The tests were performed in the range of operating parameters: IPA loading 0.18-0.26 kg/kg, voltage 19.5 V, set-point temperature 393–403 K, nitrogen flow rate 0.12 m3/h.
The analysis revealed, that raising the bed temperature resulted in an increase of desorption degree of adsorbate, reduction of regeneration time and an increase in the energy consumption. The application of insulation enabled reduction of energy consumption and regeneration time by 27% and 10%, respectively.
Greenhouse gases such as carbon dioxide and water vapour can be captured from gas streams on a zeolite 13X adsorbent. Experimental water vapour adsorption isotherms and kinetic curves were measured in the temperature range of 293–393 K and pressure up to 2100 Pa. The equilibrium data were developed with Toth and Sips multi-temperature isotherm models. The results of the process rate studies were described using pseudo-first and pseudo-second order kinetic models. Findings were compared with our own results of CO2 adsorption studies on the same zeolite.