This study presents a possibility of detecting wear of a valve plate in multi-piston axial pump based on time-frequency analysis of measured signals. Short-time Fourier transform STFT and the generalized Wigner-Ville algorithm WVD were used for this purpose. The tests were carried out on a multi-piston axial pump with swinging plate, in which the worn valve plates were mounted. Valve plate wear was related with the formation of flow micro-channels between the pump suction hole and its pumping hole on the plate transition zone surface. The developed channels initiate flow of the operational fluid, the results of which is lack of leak-tightness between suction and pumping zones, associated with a decrease in operational pressure and drop in general efficiency.
In this paper, the author presents the possibility of using phase trajectory for detecting damage in an axial piston pump. The wear on main part of pump elements, such as the rotor and the valve plate, was investigated, and phase trajectories were determined based on vibration signal measured in three directions on the pump's body. In order to obtain a quantitative measure of the analyzed trajectory, the At_{p,i} parameter was introduced, and the relation between this parameter and the wear on the pump's parts was determined.
The possibility of distinguishing and assessing the influences of defects in particular pump elements by registering vibration signals at characteristic points of the pump body would be a valuable way for obtaining diagnostic information. An effective tool facilitating this task could be a well designed and identified dynamic model of the pump. When applied for a specific type of the pump, such model could additionally help to improve its construction. This paper presents model of axial piston positive displacement pump worked out by the authors. After taking the simplifying assumptions and dividing the pump into three sets of elements, it was possible to build a discrete dynamic model with 13 degrees of freedom. According to the authors' intention, the developed dynamic model of the multi-piston pump should be used for damage simulation in its individual elements. By gradual change in values of selected construction parameters of the object (for example: stiffness coefficients, damping coefficients), it is possible to perform simulation of wear in the pump. Initial verification of performance of the created model was done to examine the effect of abrasive wear on the swash plate surface. The phase trajectory runs estimated at characteristics points of the pump body were used as a useful tool to determine wear of pump elements.