The currently applicable legal provisions and also the economic concepts emphasize the importance of circular economy. In this aspect, it is very important to reduce the waste production respectively planning and running a business. Technical research is the key to finding a new applications for waste, in particular disposed on landfilling. Mining and energy industries belong to the biggest producers of waste in Poland. The total share of these two branches in waste production is up to 70% (mining and quarrying 53%; electricity, gas, steam and air conditioning supplay 17%). In environment, economy and social aspect, it is very important to develop this waste. The paper presents research on the physico-mechanical properties of the aggregates based on colliery shale supplemented by fly ash (20% - 40% supplement of fly ash). The following tests should be mentioned among performed: particle size distribution, the sand equivalent test, freeze resistance and direct shear tests. Also the chemical properties found in the literature was invoked. The research shows good physico-mechanical properties of the mixes, such as cohesion (44.62 kPa - 68.57 kPa) or internal firiction angle (34.74° - 40.52°). Though low resistance to weathering and a large susceptibility to frost heave (the mass loss after the freezing cycles is 76%) may limit its applicatin in road engineering. The sand equivalent tests were made only for aggregates. Tested materials shows usefulness for earthen structures. However, the research should be supplemented by chemical tests and also observations of the material properties changes as the effect of time. The research on the leachability of chemical pollutants, which will determine the acceptable share of ash in the mix, could be especially significant. The fact that fly ash contains a lot of sulphates and chlorides, which leach into the environment may pose a threat to living organisms.

The road tunnel in Laliki was excavated in highly heterogeneous, severely tectonically damaged and mainly very weak rocks of the Western Carpathians flysch. In particular, the conditions were characterized by a high percentage of very weak laminated shale and weathered rock mass, an unfavorable and very steep slope of the rock layers and unstable hydrological conditions with outflows of water in loosened tectonic zones. That structure and properties of the rock mass highly uncertain. This paper describes the influence of geological engineering and geotechnical conditions on the primary lining of a main road tunnel. The deformation of the primary lining was analyzed in terms of the percentage share of sandstones and shale, geomechanical classifications RMR (Bieniawski 1989) and QTS (Tesar 1979), types of the primary lining and the use of rock bolts and micropiles. The analysis was preceded by characterization of geological engineering conditions and technological characterization of applied primary linings. Displacements of the primary lining, greater than acceptable, occurred several times in a top heading during tunneling. The primary lining was reinforced by additional rock bolts and wire mesh, a thicker layer of shotcrete and micropiles if deformation reached the emergency state for some types of linings and they didn't indicate any tendency for stabilization. The reinforcement was used until the deformation stabilization was achieved. In the most difficult conditions, the lining was reinforced by a longer micropile umbrella. Parameters for the primary lining were selected on the basis of ongoing geological engineering and geotechnical measurements, in accordance with NATM's principles. The rock mass around the tunnel in Laliki is an example of weak carrying capacity. The observed displacements in the rock mass indicate that the disturbed zone around the tunnel was heavily developed. The primary lining used in such conditions must bear a relatively high load capacity from overlying loosened material and therefore the lack of interaction with the surrounding rock mass should be assumed. The data obtained indicate that the use of the primary lining in the highly variable conditions in the Carpathian flysch requires accurate geological engineering and geotechnical analysis during the day-to-day process of tunneling in order to verify the projected assumptions. The primary linings should be reinforced as needed based on the results of geotechnical measurements, monitoring the interaction between the rock mass and the system of lining.