The results of drill stem tests made on the autochthonous Miocene deposits of the Upper Badenian - Lower Sarmatian age in the Carpathian Foredeep were analyzed. Reservoir tests were performed in open and cased holes, where inflows of formation water of varying saturation degree and sometimes contaminated with drilling mud filtrate, were observed. A total of 58 intervals, geophysically qualified as gas-bearing, were analyzed. Statistical analysis methods were used for determining the influence of the formation depth on the depth of deposition of the Miocene, and also dependence of initial back-pressure exerted on the reservoir during DST, on the depth of deposition of the reservoir. No correlation was found between water flow rate and initial differential pressure. A satisfactory correlation was obtained between hydrostatic pressure of water cushion in the tubing string and reservoir pressure for selected 22 the Miocene intervals in the Dębica region. In this region the pressure quotient php/pz broadly ranged between 0.05 and 0.57. Another correlation was noted between initial back-pressure and a depth at which pressure was measured and initial back-pressure, and formation water flow rate. The regression equations determined with statistical methods can be used for predicting values of formation pressure, initial value of back-pressure, formation water flow rate and initial differential pressure during DST. On this basis technological parameters of successive reservoir tests can be determined for in the analyzed area of the Carpathian Foredeep, particularly in the Dębica region.

In this study some of the experimental results of water shut-off treatments in oil and gas production wells were presented. The effect of water saturation of Miocene rocks of the Carpathian Foredeep on the relative permeability to gas was analyzed. Also, wide review of the worldwide publications from the point of view of the results obtained in water shut-off treatments in oil and gas formation was presented. Based on experimental results efficiency of relative permeability modification of sandstone from Szydłowiec to brine and nitrogen by four selected chemicals polymers and microgels was evaluated. Experimental results indicated that trend changes of permeability modification strongly depends on the fluid used in the RPM treatment. Moreover, efficiency of permeability modification to brine depends on flow rate of brine through the core - the lower brine flow rate the higher efficiency of the RPM treatment. RPM product number 1 caused significant loss of permeability to brine ca. 60% and slight permeability modification to gas ca. 18%. This permeability change to brine and gas was obtained by modification of formation wettability what affects well productivity. In the case of product number 2 which is based on microgels technology, also significant modification of selective permeability to brine was observed. Loss of permeability to brine was in the range of 65 to 90% while to gas ca. 50%.