A model of bacterial filtration on fibrous filter media is developed. The single fibre efficiency as well as the efficiency of the whole filter - at the onset of the process and the evolution of those quantities - are analysed. The differences between the numerical modelling of colloidal particles and bacteria are stressed in detail. The main differences are the active motion ability of bacteria and biofilm formation. The parameters of the model were identified based on the literature data.

The modelling of colloidal fouling and defouling of hollow fibre membranes in the presence of membrane oscillations is analysed by means of numerical simulations as an effect of complex coupling between hydrodynamic and surface forces. To describe the latter the Derjaguin-Landau- Vervey-Overbeek (DLVO) model has been employed. We have investigated the influence of various parameters of the process like flow rate, mean particle diameter, amplitude and frequency of the oscillations, and others, on the efficiency of the defouling process. The investigated parameters is close to that of a silica suspension in , a typical system modelling used to investigate membrane separation. On the basis of numerical simulation results e have defined an optimal set of parameters preventing membrane fouling.

A simple model of behaviour of a single particle on the bulging membrane was presented. As a result of numerical solution of a motion equation the influence of the amplitude and frequency of bulging as well as the particle size on particle behaviour, especially its downstream velocity was investigated. It was found that the bulging of a membrane may increase the mean velocity of a particle or reinforce its diffusive behaviour, dependeing on the permeation velocity. The obtained results may help to design new production methods of highly fouling-resistant membranes.

The influence of ion implantation on the structure and properties of polymers is a very complex issue. Many physical and chemical processes taking place during ion bombardment must be taken into consideration. The complexity of the process may exert both positive and negative influence on the structure of the material. The goal of this paper is to investigate the influence of H+, He+ and Ar+ ion implantation on the properties of polypropylene membranes used in filtration processes and in consequence on fouling phenomena. It has appeared that the ion bombardment caused the chemical modification of membranes which has led to decrease of hydrophobicity. The increase of protein adsorption on membrane surface has also been observed.

A significant challenge of modern technology is the design of high-efficiency filters that allow more effective removal of aerosol particles suspended in the air, e.g. micron and submicron oil droplets. Our previous work has proven that aerogel structure deposition on fibre surface is a promising method for post-production improvement of the oil-mist filter performance. In this work, a modification of the previously described method was proposed, consisting in carrying out the process in the flow (semi-batch) regime, i.e. the streams of reagents successively pass through the filter in a self-designed and self-made modification chamber. The effect of the reactant flow rate and the order of reactants (precursor/catalyst or catalyst/precursor solutions) on the mass of deposited aerogel, and thus - also on the filtration efficiency during the removal of oil mist droplets and the pressure drop accompanying the airflow - is presented and described. The possible routes of modification scaling-up are discussed with defined unit operations.