In the paper the topic of Building Information Technology BIM is investigated. It is new in Polish circumstances technology for construction and for building product industry, which contribute to change and develop level of industrialization. Especially challenge raising from the information and introducing IT technology into daily practice is considered to provide changes in construction branch of economy. In Poland there is the hot need of start to introduce BIM as the common technology for owners of assets, facility management, construction entities, design offices, administration officers and many other players relative to construction data and processes. BIM technology introduction, basing on foreign case studies, results in cost savings, control and time reduction of investment processes and some more advantages. The perspective of digital buildings, digital infrastructure, digital roads, digital railways and digital cities is outlined at the perspective of technology challenge, but simply transfiguration of many fields of personal everyday life, where digitalization is already present and with the question when it will be common in professional activity, particularly in civil engineering.

The paper presents a comparison of three strain measurement methods. The mechanical parameters of S355 grade steel (yield strength, tensile strength, modulus of elasticity) were determined in tensile tests. Strains were measured using high resolution measuring instruments: an extensometer, a strain gauge and an ARAMIS 3D DIC system. In this paper, these three instruments have been used simultaneously in tensile tests for the first time. The results indicate that the values of the Young’s modulus obtained using different techniques were similar when each instrument measured strain on the same side of the sample. Small differences were connected with different gauge lengths and their locations. The values of the Young’s modulus determined on the opposite sides of the samples were more varied even when the same method was used (strain gauge measurements). For this reason, it is recommended to use double-sided averaging instruments when the Young’s modulus is determined. The strain-curves obtained from the strain gauge measurements were incomplete and they came to an end at the end of the yield plateau due to the fact that they were damaged when the values of strain were relatively high. The extensometer was used up to the point where the strain reached 0.3% and then the strain was measured based on the distance between the machine clamps. The stress-strain curves obtained from the DIC system were complete because the system was able to monitor the sample until the very end of the tests.