The work presents examination results of the common determination of PAHs and PCBs in industrial sludge and supernatants. Sewage sludge was taken from the wastewater treatment plant, and supernatants were obtained by their centrifuging. The prepared samples of sewage sludge and supernatants were subjected to extraction with applying the mixture of organic solvents. Cyclohexane and dichloromethane were used for constant samples, and methanol, cyclohexane and dichloromethane - for liquid. Extracts, after separation from samples of sewage sludge and supernatants, were cleared on the silica gel in vacuum conditions and concentrated in the stream of nitrogen. In such prepared extracts there was conducted the qualitative-quantitative analysis of 16 PAHs using the GC-MS system. Next, the samples were evaporated and poured with water and methanol until the clear solution was obtained. Extracts were cleared on octadecyl C18 columns, and then concentrated in the nitrogen stream. In these extracts PCBs was also determined with the application of the gas chromatograph with mass spectrometer. The range of concentrations 16 PAHs in sewage sludge equalled 10-16 mg/kgd.w. Summary average concentration 16 PAHs in supernatants was reached 17 μg/L. Average recovery of PAHs introduced to sewage sludge in the form of reference mixture was 78% (with consideration of naphthalene). In the case of supernatants, the average value of recovery reached 60%. Average PCBs concentration in supernatants equalled 10 ng/L. For sewage sludge the sum of marked PCBs was an average 1.23 μg/kgd.w.. In the case of particular PCBs the percentage recovery of the reference mixture for supernatants was 86%, while for sewage sludge it was 55%.

The aim of this work was to determine the influence of various variants of bioleaching on effectivity of releasing chosen critical metals: rhodium, cadmium, indium, niobium and chromium from ashes which are a byproduct of municipal waste and sewage sludge thermal processing. The research was conducted in 3 variants that considered different process factors such as temperature (24ºC and 37ºC), mixing intensity and aeration. After 5 days of the process the analyses were made of metals content, sulfate concentration, pH, general number of bacteria number, index of sulfur oxidizing bacteria. The best results of bioleaching were achieved by running the process at the temperature of 24ºC with aeration. The efficiency of rhodium and cadmium release from the byproduct of municipal waste thermal processing was above 90%. The efficiency of indium and chromium release reached 50–60%. Only niobium leached better in mixing conditions. The byproduct of sewage sludge thermal processing was far less susceptible to bioleaching. The highest effectivity (on a level of 50%) was reached for indium in temperature of 24°C with aeration. The efficiency of bioleaching depended on waste’s physiochemical properties and type of metal which will be released. Aeration with compressed air had a positive influence on the increase of sulfur oxidizing bacteria what corresponded with almost double increase of sulfate concentration in leaching culture. Such conditions had a positive influence on the increase of the efficiency of bioleaching process. Heightening the temperature to 37°C and slowly mixing did not impact bioleaching in a positive way.