Liquid metal extraction (LME) process results in 100% neodymium (Nd) extraction but the highest extraction efficiency reported for Dysprosium (Dy) so far is 74%. Oxidation of Dy is the major limiting factor for incomplete Dy extraction. In order to enhance the extraction efficiency and to further investigate the limiting factors for incomplete extraction, experiments were carried out on six different particle sizes of under 200 µm, 200-300 µm, 300-700 µm, 700-1000 µm, 1000-2000 µm and over 2000 µm at 900℃ with magnesium-to-magnet scrap ratio of 15:1 for 6, 24 and 48 hours, respectively. This research identified Dy2Fe17 in addition to Dy2O3 phase to be responsible for incomplete extraction. The relationship between Dy2Fe17 and Dy2O3 phase was investigated, and the overall extraction efficiency of Dy was enhanced to 97%.
Recently, since the demand of rare earth permanent magnet for high temperature applications such as an electric motor has increased, dysprosium (Dy), a heavy rare earth element, is becoming important due to severe bias in its production. To fulfill the increasing need of Dy, recycling offers as a promising alternative. In recycling of rare earths, Hydro-metallurgical extraction method is mainly used however it has adverse environmental effects. Liquid metal extraction on the other hand, is an eco-friendly and simple method as far as the reduction of rare earth metal oxide is concerned. Therefore, liquid metal extraction was studied in this research as an alternative to the hydro-metallurgical recycling method. Magnesium (Mg) is selected as solvent metal because it doesn’t form intermetallic compounds with Fe, B and has a low melting and low boiling point. Extraction behavior of Dy in (Nd,Dy)-Fe-B magnet is observed and effect of Mg ratio on extraction of Dy is confirmed.
NdFeB anisotropic sintered permanent magnets are typically fabricated by strip casting or melt spinning. In this study, the plastic deformability of an NdFeB alloy was investigated to study the possibility of fabricating anisotropic sintered magnets using gas atomized powders. The results show that the stoichiometric composition Nd12Fe82B6 softens at high temperatures. The aspect ratio and orientation factor of Nd12Fe82B6 billets after plastic deformation were found to increase with increasing plastic deformation temperature, particularly above 800℃. This confirms that softening at high temperatures can lead to plastic deformation of Nd2Fe14B hard magnetic phases.