NC11 steel, in view of the specificity of its manufacturing process, is characterised with band-like orientation of carbides. Depending

on the direction of cutting the material for the inserts out of commercially available steel products, carbide bands can be oriented

in parallel or perpendicularly to the direction in which aggregate grains move in the process of pressing stampings. It has been found that

in case of scratches made in direction perpendicular to carbide bands, depth of the scratches is less than this observed when scratches are

made in direction coinciding with prevailing orientation of carbide precipitates.

The paper presents results of assessment of the unit pressure force within the refractory material volume in the course press-moulding of

stampings for refractory precast shapes. The force was evaluated with the use of physical simulation of deformation undergone by lead

balls placed in the raw refractory mass subjected to pressing in a metal die. To determine the value of unit pressure force applied to the

aggregate grains in the course of stamping press-moulding, physical model of deformation of a sphere induced by the uniaxial stress state

was used.

The paper presents results of an analysis of material density distribution in stampings press-moulded in metal dies from raw refractory

materials based on alumina-magnesia-carbon aggregate. The stampings, fabricated on LAEIS HPF 1250 pressing machine, are blanks from

which refractory precast shapes are manufactured by means of drying and firing. Samples for material density evaluation were cut out

from test stampings with the use of diamond-reinforced disc. Density of the material was determined in thirteen layers of stampings

denoted with letters A through M.