Chemical heat pumps (CHP) use reversible exothermal and endothermal chemical reactions to increase the temperature of working fluids. In comparison to the “classical” vapour compression chemical heat pumps, CHP enables us to achieve significantly higher temperatures of a heated medium which is crucial for the potential application, e.g. for production of superheated steam. Despite the advantages presented, currently, there are no installations using CHP for lowgrade waste heat recovery available on the market. The scaling up of industrial processes is still one of the greatest challenges of process engineering. The aim of the theoretical and experimental concept study presented here was to evaluate a method of reclaiming energy from low temperature waste streams and converting it into a saturated steam of temperature from 120 to 150 ◦C, which can be useful in industry. A chemical heat pump concept, based on the dilution and concentration of phosphoric acid, was used to test the method in the laboratory scale. The heat of dilution and energy needed for water evaporation from the acid solutionwere experimentally measured. The cycle of successive processes of dilution and concentration has been experimentally confirmed. A theoretical model of the chemical heat pump was tested and coefficient of performance measured.

In order to assess the influence of hydrodynamic effects on the recovery of n-butanol by means of pervaporation, a commercial PERVAP 4060 membrane was investigated. Laboratory pervaporation experiments were carried out providing a comparison of the permeation fluxes and enrichment factors. While the enrichment factors achieved in both modules under the same process conditions were comparable, the permeation fluxes differed from each other. In order to explain the observed differences, hydrodynamic conditions in the membrane module were examined by means of CFD simulation performed with ANSYS Fluent 14.5 software. Two different modules having membrane diameters of 80 mm and 150 mm were analyzed. As a result, different velocity profiles were obtained, which served to estimate the mass transfer coefficients of butanol, ethanol and acetone.