Cold spraying as a low-temperature coating deposition method is intended for thermally sensitive materials. Due to its precise temperature control, it limits the formation of structural defects, and can therefore be easily applied to spray corrosion protective coatings made from metal or metal-ceramic powders. However, the formation of pure ceramic coatings with the use of cold spraying is still not so common. Titanium dioxide is one of the most interesting ceramics due to its photocatalytic properties. Nevertheless, these types of coating materials usually work in a corrosion favoring humid atmosphere. In the presented paper, amorphous TiO2 powder was deposited onto aluminum alloys and steel substrates and then submitted to potentiodynamic corrosion tests in a 3.5 wt.% NaCl solution. The as-sprayed coating showed phase transition from amorphous TiO2 to anatase, and also revealed porosity. As a result, electrolytes penetrated the coating and caused undercoating corrosion in the tested environment of an aqueous NaCl solution. The analysis of the potentiodynamic curves showed that the presence of the coating decreased corrosion potential on both substrates. It arose from the mixed phases of TiO2, which consisted of photocathode – amorphous material and photoanode – crystalline anatase. The phase mixture induced the galvanic corrosion of metallic substrates in the presence of electrolytes. Moreover, pitting-like corrosion and coating delamination were detected in aluminium alloy and steel samples, respectively. Finally, the corrosion mechanism of the titanium dioxide coatings was characterized and described.

Thermal spraying methods are commonly used to regenerate damaged surface or change materials surface properties. One of the newest methods is cold spraying, where coating is deposited of material in the solid state. Therefore shape and size of the powder particles are very important parameters. The article presents the influence of copper powder morphology on mechanical properties of the coatings (adhesion, hardness, Young’s modulus) deposited with the Low Pressure Cold Spraying method on the AA1350 aluminium alloy substrate. The coatings were deposited using two commercially available copper powders with spherical and dendritic morphology and granulation of –40+10 µm. The bond strength of coatings was determined with the pull off method, the hardness with the Vickers method at load of 2.94 N, while the Young’s modulus through measurement of nanoindentation. Microstructure of the coatings was analysed using the light and scanning electron microscopy (SEM). Shape of the powder influences mechanical properties of the coating significantly. The coatings deposited with dendritic powder had low mechanical properties, hardness of the 81 HV0.3 order and adhesion of about 4 MPa. However changing powder morphology to spherical increased hardness of the coating to 180 HV0.3 and adhesion to 38.5 MPa.