This paper deals with the experimental validation of the suitability of the method for measuring radial variations of components on the process tool. The tests were conducted using a computerized PSA6, which was compared to a Talyrond 73. The results of measurement of roundness deviations as well as roundness profiles were analyzed for a sample of 70 shafts. The roundness deviations were assessed by determining the experimental errors, while the profiles obtained with the tested device were compared to those registered by the reference device using three correlation coefficients.

The paper describes the influence of the machining operation on a surface, which disturbs the projection of the tool profile in the form of its relative movements with respect to the object. The elements of the machine tool undergo constant wear during the machining process, it is therefore important to recognize the effects of their influence on the surface's irregularities. Amplitude-frequency analysis of lateral profiles has been used to evaluate and changes of turned lateral profiles. The results of simulation of radial and axial effects of the machine tool on surface and their spectral components were analyzed. Surfaces obtained in similar machining conditions on lathes operated in various time periods were analyzed spectrally. From the analysis of surface irregularity changes caused by disturbances in movements of the tool against the object, testifying the wear of main machine elements during its operation, the modulated, amplitude-frequency character of changes in surface irregularities of workpiece can be noticed.