The material selected for this investigation was low alloy steel weld metal deposit (WMD) after MAG welding with micro-jet cooling. The

present investigation was aimed as the following tasks: analyze impact toughness of WMD in terms of micro-jet cooling parameters. Weld

metal deposit (WMD) was first time carried out for MAG welding with micro-jet cooling of compressed air and gas mixture of argon and

air. Until that moment only argon, helium and nitrogen and its gas mixture were tested for micro-jet cooling

In this study, the microstructures and mechanical properties of X70 pipeline steels produced with varying Mo contents, accelerated cooling rate and intermediate slab blank thickness are systematically investigated. Results showed that the microstructures and mechanical properties of the X70 pipeline steels were strongly affected by Mo addition. The pearlite and proeutectoid ferrite formation is obviously inhibited in containing-Mo steel and the acicular ferrite (AF) is obtained in a wide range of cooling rates. With the increasing the cooling rates, the AF constituent amount increases. The grains can be refined by increasing the thickness of intermediate slab for enhancing the cumulative reduction rates, and meanwhile increase the number density of precipitates. It was proved by simulation and industrial trials that the low-alloy X70 pipeline steels can be produced increasing cooling rates and the thickness of intermediate slab without strength and toughness degradation which also reduce alloy cost.

In-situ observation of the transformation behavior of acicular ferrite in high-strength low-alloy steel using confocal laser scanning microscopy was discussed in terms of nucleation and growth. It is found that acicular ferrite nucleated at dislocations and slip bands in deformed austenite grains introduced by hot deformation in the non-recrystallization austenite region, and then proceeded to grow into an austenite grain boundary. According to an ex-situ EBSD analysis, acicular ferrite had an irregular shape morphology, finer grains with sub-grain boundaries, and higher strain values than those of polygonal ferrite. The fraction of acicular ferrite was affected by the deformation condition and increased with increasing the amount of hot deformation in the non-recrystallization austenite region.