Structures and characteristics ofwideband small-size phase shiftersmade with the use of single parallel stubs are presented in this paper. The stubs can be short-circuited or open-circuited on termination. Such devices arewell known, but are primarily used as components of filters ormatching circuits. The novelty, then, comes from the establishment of simple, but helpful formulae, which enable to describe the insertion phase shift and differential phase shift of a line with short and open stubs connected in parallel. These equations can be very useful for designing complex microwave multi-ports. The results of simulations and measurements of the devices, which were designed and made, are shown herein. It was also proved that the presented devices have several usable operating frequency sub-bands, and that the differential phase shift values in the higher sub-bands are greater than those in the lower operating frequency ranges. Thanks to this, the described phase shifters can be used in more than one frequency sub-band. It was stated that in the conditions under analysis, larger phase shifts can be achieved using open-circuited stubs rather than short-circuited stubs. However, the phase shifters with shorted parallel stubs can operate in a wider frequency band.

The paper investigates the interdependence between the perceptual identification of the vocalic quality of six isolated Polish vowels traditionally defined by the spectral envelope and the fundamental frequency F0. The stimuli used in the listening experiments were natural female and male voices, which were modified by changing the F0 values in the ±1 octave range. The results were then compared with the outcome of the experiments on fully synthetic voices. Despite the differences in the generation of the investigated stimuli and their technical quality, consistent results were obtained. They confirmed the findings that in the perceptual identification of vowels of key importance is not only the position of the formants on the F1 × F2 plane but also their relationship to F0, the connection between the formants and the harmonics and other factors. The paper presents, in quantitative terms, all possible kinds of perceptual shifts of Polish vowels from one phonetic category to another in the function of voice pitch. An additional perceptual experiment was also conducted to check a broader range of F0 changes and their impact on the identification of vowels in CVC (consonant, vowel, consonant) structures. A mismatch between the formants and the glottal tone value can lead to a change in phonetic category.

The paper presents the idea to improve the performance of thin film photovoltaic cells by a light capture enhancement through the introduction of down shifting energy converters. Luminescent down shifting layers convert high-energy photons (UV light) into low-energy ones (visible light), which are more efficient in a photovoltaic conversion. For this purpose, the application of a thin layer composed of zinc oxide (ZnO) nanoparticles deposited onto a thin film solar cell is proposed. The paper presents both experimental and theoretical results of this approach. Conducted investigations include an analysis of ZnO nanoparticle layers, deposited in two independent technology methods. The results showed that ZnO nanoparticles have a great potential of application as down converting layers and can be implemented to improve the efficiency of photovoltaic cells, especially in the field of thin film PV structures. The proposed new deposition method can potentially be used in some industrial photovoltaic applications.

While assessing the effects of climate change at global or regional scales, local factors responsible for climate change are generalized, which results in the averaging of effects. However, climate change assessment is required at a micro-scale to determine the severity of climate change. To ascertain the impact of spatial scales on climate change assessments, trends and shifts in annual and seasonal (monsoon and non-monsoon), rainfall and temperature (minimum, average and maximum) were determined at three different spatial resolutions in India (Ajmer city, Ajmer District and Rajasthan State). The Mann–Kendall (MK), MK test with pre-whitening of series (MK–PW), and Modified Mann–Kendall (MMK) test, along with other statistical techniques were used for the trend analysis. The Pettitt–Mann–Whitney (PMW) test was applied to detect the temporal shift in climatic parameters. The Sen’s slope and % change in rainfall and temperature were also estimated over the study period (35 years). The annual and seasonal average temperature indicates significant warming trends, when assessed at a fine spatial resolution (Ajmer city) compared to a coarser spatial resolution (Ajmer District and Rajasthan State resolutions). Increasing trend was observed in minimum, mean and maximum temperature at all spatial scales; however, trends were more pronounced at a finer spatial resolution (Ajmer city). The PMW test indicates only the significant shift in non-monsoon season rainfall, which shows an increase in rainfall after 1995 in Ajmer city. The Kurtosis and coefficient of variation also revealed significant climate change, when assessed at a finer spatial resolution (Ajmer city) compared to a coarser resolution. This shows the contribution of land use/land cover change and several other local anthropogenic activities on climate change. The results of this study can be useful for the identification of optimum climate change adaptation and mitigation strategies based on the severity of climate change at different spatial scales.

In many countries, rapid secularisation exerts an ever growing control over nearly every aspect of social life, driving Christianity away from public life and substitu-ting it with an increasingly militant ideology. Christianity today faces many questions and challenges, from profound shifts in traditional values and new anthropologies to questions on the meaning of life and the place of the Church in pluralistic society. Do the Christians of today have anything to offer in the modern Areopagus of thought? Though in minority during the first few centuries of their history, Christians not only were able to claim their due place in society, but point to their contribution to its well-being and functioning. After the so-called Edict of Milan they tried to influence legislation and imbue it with the values and spirit of the Gospel. Not always was it possible, though. At times the border between the state and the Church were crossed either way. Nevertheless, in order to safeguard the autonomy of the Church in her re-lationship with the state, the former tried to adhere to the wise principle she received from her Founder to give back to Caesar what is Caesar’s, and to God what is God’s.

A class of Xorshift Random Number Generators (RNGs) are introduced by Marsaglia. We have proposed an algorithm which constructs a primitive Xorshift RNG from a given prim- itive polynomial. We also have shown a weakness present in those RNGs and suggested its solution. A separate algorithm also proposed which returns a full periodic Xorshift generator with desired number of Xorshift operations.

Due to the skin effect of eddy currents, the depth of cracks which can be detected by the traditional eddy current probe is very limited. In order to improve the ability of eddy current probes to inspect deep cracks in metal thick-walled structures, a new eddy current probe using an excitation system with phase shifted fields was proposed. Its feasibility for detecting deep cracks was verified by simulation and experiments. The results showed that the penetration depth of eddy currents in austenitic stainless steel is effectively enhanced by using the new probe.

Heavy metal ions (e.g. cadmium, chromium, copper, nickel, arsenic, lead, zinc) have significantly serious side effects on the human health. They can bind with proteins and enzymes, altering their activity, increasing neurotoxicity, generating reactive oxygen species (ROS), promote cellular stress and resulting in their damage. Furthermore, the size, shape and type of metal are important for considering nano- or microtoxicity. It then becomes clear that the levels of these metals in drinking water are an important issue. Herein, a new micro-mechanical sensor is proposed to detect and measure these hazardous metals. The sensor consists of a micro-beam inside a micro-container. The surface of the beam is coated with a specific protein that may bind heavy metals. The mass adsorbed is measured using the resonant frequency shift of the micro-beam. This frequency shift due to the admissible mass (which is considered acceptable for drinking water based on the World Health Organization (WHO) standard) of manganese (Mn), lead (Pb), copper (Cu) and cadmium (Cd) is investigated for the first, second and third mode, respectively. Additionally, the effects of micro-beam off-center positions inside the micro-container and the mass location are investigated.