The article presents research results of physico-chemical and environmental issues for the dust generated during dedusting of the

installation for the processing and preparation of moulding sand with bentonite. Particular attention was paid to the content of heavy

metals and emission of gases from the BTEX group, which is one of the determinants of the moulding sands harmfulness for the

environment. The analysis of heavy metals in the test samples indicate that there is an increase of the content of all metals in the dust

compared to the initial mixture of bentonite. The most significant (almost double) increase observed for zinc is probably related to the

adsorption of this element on the dust surface by contact with the liquid metal. The study showed, that dust contained more than 20% of

the amount of montmorillonite and had a loss on ignition at a similar level. The addition of 1% of dust to the used moulding sand results in

almost 30% increase in the total volume of gases generated in casting processes and nearly 30% increase of the benzene emission.

The paper presents the results of thermoanalytical studies by TG/DTG/DTA, FTIR and GC/MS for the oil sand used in art and precision foundry. On the basis of course of DTG and DTA curves the characteristic temperature points for thermal effects accompanying the thermal decomposition reactions were determined. This results were linked with structural changes occurred in sample. It has been shown that the highest weight loss of the sample at temperatures of about 320°C is associated with destruction of C-H bonds (FTIR). In addition, a large volume of gases and high amounts of compounds from the BTEX group are generated when liquid metal interacts with oil sand. The results show, that compared to other molding sands used in foundry, this material is characterized by the highest gaseous emissions and the highest harmfulness, because benzene emissions per kilogram of oil sand are more than 7 times higher than molding sand with furan and phenolic binders and green sand with bentonite and lustrous carbon carrier.

The furan resin offers advantages such as high intensity, low viscosity, good humidity resistance and is suitable for cast different casting

alloys: steel, cast iron and non-ferrous metal casting. For hardening furan resins are used different hardeners (acid catalysts). The acid

catalysts have significant effects on the properties of the cured binder (e,g. binding strength and thermal stability) [1 - 3]. Investigations of

the gases emission in the test foundry plant were performed according to the original method developed in the Faculty of Foundry

Engineering, AGH UST. The analysis is carried out by the gas chromatography method with the application of the flame-ionising detector

(FID) (TRACE GC Ultra THERMO SCIENTIFIC).

A large number of defects of castings made in sand moulds is caused by gases. There are several sources of gases: gases emitted from moulds, cores or protective coatings during pouring and casting solidification; water in moulding sands; moisture adsorbed from surroundings due to atmospheric conditions changes. In investigations of gas volumetric emissions of moulding sands amounts of gases emitted from moulding sand were determined - up to now - in dependence of the applied binders, sand grains, protective coatings or alloys used for moulds pouring. The results of investigating gas volumetric emissions of thin-walled sand cores poured with liquid metal are presented in the hereby paper. They correspond to the surface layer in the mould work part, which is decisive for the surface quality of the obtained castings. In addition, cores were stored under conditions of a high air humidity, where due to large differences in humidity, the moisture - from surroundings - was adsorbed into the surface layer of the sand mould. Due to that, it was possible to asses the influence of the adsorbed moisture on the gas volumetric emission from moulds and cores surface layers by means of the new method of investigating the gas emission kinetics from thin moulding sand layers heated by liquid metal. The results of investigations of kinetics of the gas emission from moulding sands with furan and alkyd resins as well as with hydrated sodium silicate (water glass) are presented. Kinetics of gases emissions from these kinds of moulding sands poured with Al-Si alloy were compared.