To further improve the mechanical properties of carbon nanotubes (CNTs) modified aluminum alloy (ZL105), the first principle was used to build the atomic structure of the alloy system and the alloy system was simulated by the VASP. After that, the heat treatment process of the cast aluminium alloy material with CNTs to enhance the alloy performance by the orthogonal experiment. The results of the research show that: (1) The energy status of the alloy system could be changed by adding the C atoms, but it did not affect the formation and structural stability of the alloy system, and the strong bond compounds formed by C atoms with other elements inside the solid solution structure can significantly affect the material properties. (2) The time of solid solution has the greatest influence on the performance of material that was modified by CNTs. The solution temperature and aging temperature were lower strength affection, and the aging time is the lowest affection. This paper provides a new research method of combining the atomic simulation with the casting experiment, which can provide the theoretical calculations to reduce the experiment times for the casting materials’ performance improvement.

Ceramic waste generated by demolition and manufacturing processes is a kind of widely discharged solid waste; its sustainable use can reduce resource extraction, energy consumption, and carbon emissions, thereby reducing the environmental impact. In this study, ceramic powder and ceramic sand were prepared using waste ceramic wall tiles. By using three water-to-binder ratios of 0.30, 0.32, and 0.34, five ceramic powder replacement rates of 10% to 50%, and completely using ceramic sand as the fine aggregate, specimens with large differences in mechanical properties were prepared. Firstly, the compressive strength was investigated. On this basis, hybrid fibers were employed to strengthen the new matrix material, and its bending resistance was experimentally studied. It was found that the incorporation of ceramic powder reduced the compressive strength of the matrix. The water-binder ratio significantly affects compressive strength at an early age. The effect of PVA fiber on improving the ductility of the new composite is distinct. Increasing the amount of steel fiber can effectively enhance the bending bearing capacity.With a ceramic powder dosage of 50%, the new composite has shown ductile failure characteristics, even with low total fiber content. The bending properties of this new composite material, which makes extensive use of ceramic waste, are well adjustable. The bearing capacity and ductility balance can be achieved with the steel fiber content of 1% and the PVA fiber content of 1.2% to 1.50%.

Escalating quantity of industrial by-products generated, including oil palm shell (OPS) and palm oil fuel ash (POFA ) of the palm oil industries, has been a concern to many analysts. They are mostly disposed off as wastes that would heavily impact the environment quality. Therefore, this paper aimed to investigate the possibility of consuming these wastes by using OPS and POFA as replacement materials for fine aggregates in the concrete mixture. The mixtures were prepared by integrating unground palm oil fuel ash of 0%, 10%, and 20% (by weight of sand) to produce lightweight concrete. The experiments observed the mechanical performance of these specimens for 180 curing days. The results show the enhancement of concrete strength relative to the control mixture by using 10% of ash. This is owing to void filling mechanism and product of pozzolanic reaction due to the fine particles of the ash.