Coal ash produced from thermal power plants as a substitute for conventional construction material has increased considerably in recent years. In the past, studies on partial replacement of soil were carried out with a single type of ash. Because of the insufficient evidence, limited research has been initiated on the productive usage of Fly and Bottom Ashes. This paper aims to study the properties of these materials and investigate their efficacy in road construction. Laboratory investigations were conducted to assess chemical and physical properties and mechanical performance to evaluate both ash types in pavement construction. The rutting factor is calculated for various combinations of coal ash materials with the addition of polypropylene fiber as a reinforcement in increments of 0.1% of its total weight with an aspect ratio of 200. The analytical tool ANSYS is used to validate the service life, vertical strain and quality of reinforced ash materials.

Synthetic polymer latexes, such as styrene–butadiene rubber (SBR) latex addition in Portland cement has gained wider acceptance in many applications in the construction industry. Polymer-modified cementitious systems seals the pores and micro cracks developed during hardening of the cement matrix, by dispersing a film of polymer phase throughout the concrete. A comprehensive set of experimental test were conducted for studying the compressive properties of SBR latex polymer with crimped polypropylene fibres at relative volume fractions of 0.1 and 0.3%. The results indicated that the addition of polypropylene fibre has little effect on the reduction in the workability of concrete composite containing fly ash and SBR Latex. Increase in polypropylene fibres upto 0.3% Vf showed increase in compressive strength upto 57.5 MPa. The SBR concrete without fibre showed an increase in strength upto 20% compared to plain concrete. Test results also indicated that the compressive strength was increased in SBR fibre concrete by means of an ordinary dry curing process than wet curing because of their excellent water retention due to polymer film formation around the cement grains. On the contrary the compressive strength reduces for SBR fibre concretes under wet curing compared to dry curing.