Speech and music signals are multifractal phenomena. The time displacement profile of speech and music signal show strikingly different scaling behaviour. However, a full complexity analysis of their frequency and amplitude has not been made so far. We propose a novel complex network based approach (Visibility Graph) to study the scaling behaviour of frequency wise amplitude variation of speech and music signals over time and then extract their PSVG (Power of Scale freeness of Visibility Graph). From this analysis it emerges that the scaling behaviour of amplitude-profile of music varies a lot from frequency to frequency whereas it’s almost consistent for the speech signal. Our left auditory cortical areas are proposed to be neurocognitively specialised in speech perception and right ones in music. Hence we can conclude that human brain might have adapted to the distinctly different scaling behaviour of speech and music signals and developed different decoding mechanisms, as if following the so called Fractal Darwinism. Using this method, we can capture all non-stationary aspects of the acoustic properties of the source signal to the deepest level, which has huge neurocognitive significance. Further, we propose a novel non-invasive application to detect neurological illness (here autism spectrum disorder, ASD), using the quantitative parameters deduced from the variation of scaling behaviour for speech and music.
The article proves that common LEDs may act as photodetectors with limited sensitivity, if they are polarized with an appropriate reverse voltage. The measured responsivities are ranged between 0.002 and 0.156 A/W and they depend on the LED type. The only one exception are white (phosphorescent) LEDs which do not exhibit any photosensitivity. There have also shown that a bandwidth of LEDs, which were examined in a role of photodetectors, is of a few tens of MHz, which is an order of magnitude greater than their modulation bandwidth as transmitters. The reasons of the observed LEDs behaviour are explained theoretically. The obtained results are indicated that some of them may be used as both transmitters and receivers in the VLC links working in a bi-directional half-duplex mode.
Range-gated-imaging system, which can be used to eliminate backscatter in strong scattering environments, is based on two high speed technologies. It uses high power, ultra-short pulse laser as the light source. And it opens the optical gate of an ICCD camera with a micro-channel-plate image intensifier in a very short time while the laser pulses reflected by the object is coming back to the ICCD camera. Using this range-gated-imaging technology, the effect of scattered light can be reduced and a clear image is obtained.
In this paper, the test results of the range-gated-imaging system under dense aerosol environments, which simulates environments in the reactor containment building when the severe accident of the nuclear power plant occurred, are described. To evaluate the observation performance of the range-gated-imaging system under such dense fog environment, we made a test facility. Fog particles are sprayed into the test facility until fog concentration is reached to the postulated concentration level of the severe accident of the nuclear power plant. At such dense fog concentration conditions, we compared and evaluated the observation performances of the range-gated-imaging system and the CCD camera.
The presented work proposes a new dimming control schemes for indoor visible light communication which combines variable pulse-position modulation, colour shift keying as key schemes of IEEE 802.15.7 standard, and sub carrier-pulse-position modulation as a pulse-position modulation variant with orthogonal frequency division multiplexing. These schemes are then compared with traditional merging schemes utilizing pulse-width modulation and multiple pulse-position modulation with m-ary quadrature amplitude modulation OFDM. The proposed schemes are investigated in a typical room with a different lighting layout (i.e., distinctive and uniform lighting layout), followed by an illumination investigation to evaluate the performance of the proposed schemes, especially the enhanced achieved data rates, and to determine their limitations as reliable visible light communication systems that can satisfy both communication and illumination requirements.