New materials require the use of advanced technology in manufacturing parts of complex shape. One of the modern non-conventional technology of manufacturing difficult to cut materials is the wire electrical discharge machining (WEDM). The article presents the results of theoretical and experimental research in the influence of the WEDM conditions and parameters on the shape deviation during a rough cut. A numerical model of the dielectric flow in the gap (ANSYS) was developed. The influence of the dielectric velocity field in the gap on the debris evacuation and stability of WEDM process was discussed. Furthermore, response surface methodology (RSM) was used to build empirical models for influence of the wire speed Vd, wire tension force Fn, the volume flow rate of the dielectric Qv on the flatness deviation after the WEDM.

Recent developments in automation and technology have revolutionized the way products are made. It is directly seen in the evolution of part miniaturization in the sectors such as aerospace, electronics, biomedicine and medical implants. Micromachining is a promising technology to fulfill the need of miniaturization. A review has been done on the micromachining processes such as micro electric discharge machining (micro-EDM) and wire EDM (WEDM), micro electrochemical machining (micro-ECM). Recent literature were studied and categorized in terms of materials, process parameters, performances, product manufactured, and miniature product generation. Starting with brief introduction to micromachining, classifications and applications, technical aspects of discussions from the literature have been presented on key factors such as parameters and the response variables. Important aspects of recast layer, heat effected zone, micro-hardness, micro cracks, residual stress, etc., have been given. A special focus is given to the status of the research on microgear manufacturing. Comparison has been made between other conventional process suitable for micro-gear manufacturing and WEDM. The miniature gear machined by WEDM shows the defect-free microstructure, better surface finish, thin recast layer and improved gear quality parameters such as profile and pitch. Finally, the research gaps and future research directions have been presented.