This paper presents possibilities for of numerical modelling of biomass combustion in a commercially available boiler. A sample of biomass was tested with respect to its physical and chemical properties. Thermogravimetry studies of biomass were carried out. Computer simulation makes it possible to analyse complex phenomena which are otherwise difficult to observe. The aim of this work was to model biomass combustion to predict the amount of pollutants generated (NOx, CO, SO2) in the exhaust gases coming out from boilers The calculations were made using the CHEMKIN program. Results of calculations were performed taking into account the influence of temperature, pressure and residence time.

Protection of the environment and counteracting global warming require finding alternative sources of energy. One of the methods of generating energy from environmentally friendly sources is increasing the share of gaseous fuels in the total energy balance. The use of these fuels in compression-ignition (CI) engines is difficult due to their relatively high autoignition temperature. One solution for using these fuels in CI engines is operating in a dualfuel mode, where the air and gas mixture is ignited with a liquid fuel dose. In this method, a series of relatively complex chemical processes occur in the engine's combustion chamber, related to the combustion of individual fuel fractions that interact with one another. Analysis of combustion of specific fuels in this type of fuel injection to the engine is difficult due to the fact that combustion of both fuel fractions takes place simultaneously. Simulation experiments can be used to analyse the impact of diesel fuel combustion on gaseous fuel combustion. In this paper, we discuss the results of simulation tests of combustion, based on the proprietary multiphase model of a dual-fuel engine. The results obtained from the simulation allow for analysis of the combustion process of individual fuels separately, which expands the knowledge obtained from experimental tests on the engine.

The development of combustion systems construction is associated with the possibility of increasing the thermal or overall efficiency of an internal combustion engine. The combustion systems currently in use (mainly related to direct fuel injection) are increasingly being replaced by hybrid systems, including direct and indirect injection. Another alternative is the use of prechambers in new combustion systems. This article concerns the thermodynamic aspect of this issue – namely, the assessment of the inter-chamber flow of a marine engine equipped with a prechamber combustion spark ignition system. The research was carried out using mainly one-dimensional simulation apparatus, and detailed analyses were presented using three-dimensional modeling. The tests included the engine model at medium load. Differences in mass flows were shown at different diameters and different numbers of holes from the preliminary chamber (while maintaining the same cross-sectional area). Similar values of excess air coefficient during ignition of the fuel dose in the prechamber were observed, which resulted in changes in the flow between the prechamber and the main chamber. The differences in mass flow affected the temperatures achieved in the individual combustion chambers. Based on three-dimensional analyses, the mass transfer rate between the chambers and the temperature distribution were assessed during fuel ignition initiated in the prechamber.

In this work problems associated with requirements related to pollution emissions in compliance with more restrictive standards, low-emission combustion technology, technical realization of the monitoring system as well as algorithms allowing combustion process diagnostics are discussed. Results of semi-industrial laboratory facility and industrial (power station) research are presented as well as the possibility of application of information obtained from the optical fibre monitoring system for combustion process control. Moreover, directions of further research aimed to limit combustion process environmental negative effects are presented.