Novel method of space-vector-based pulsewidth modulation (PWM) has been disseminated for synchronous control of four inverters feeding six-phase drive based on asymmetrical induction motor which has two sets of windings spatially shifted by 30 electrical degrees. Basic schemes of synchronized PWM, applied for control of four separate voltage source inverters, allow both continuous phase voltages synchronization in the system and required power sharing between DC-sources. Simulations show a behavior of six-phase system with continuous and discontinuous versions of synchronized PWM.

Fractional-slot concentrated-winding permanent magnet synchronous machines (FSCW-PMSMs) have a good prospect of application in the drive system of electric and hybrid electric vehicles. However, the armature magnetomotive force (MMF) of FSCWPMSM contains a large number of space harmonics, which induce large magnet eddycurrent loss (ECL). To solve this problem, a dual three-phase 10-pole and 24-slot winding layout is proposed.MMFharmonic analysis shows that the 1st, 7th and 17th space-harmonic winding factors of the proposed winding can be reduced by 100%, 87% and 87% respectively, compared with a dual three-phase 10-pole and 12-slot winding. Electromagnetic performances of the proposed machine under rated sinusoidal current supply and space vector pulse-width-modulated (SVPWM) voltage supply are investigated based on 2D finite-element analysis. It is shown that the proposed machine can meet the requirement of torque and efficiency in the full speed range. Especially, magnet ECL can be reduced greatly due to the reduction of the 7th and 17th space harmonics.

The development of electric vehicles (EV) necessitates the search for new solutions for configuring powertrain systems to increase reliability and efficiency. The modularity of power supplies, converters, and electrical machines is one such solution. Among modular electric machines, dual three-phase (DTP) motors are the most common in high-power drives. To simplify low and medium power drives for EVs based on DTP PM motor, it is proposed to use a BLDC drive and machine of the simplest design – with concentrated windings and surface mounted PMs on the rotor. To study and create such drives, an improved mathematical model of DTP PM machine was developed in this work. It is based on the results of 2D FEM modeling of the magnetic field. According to the developed method, the dependences of the self and mutual inductances between all phase windings from the angle of rotor position and loads of different motor modulus were determined. Based on these inductances, the circuit computer model of DTP PM machine was created in the Matlab/Simulink. It has a high simulation speed and a high level of adequacy, which is confirmed by experimental studies with a mock-up sample of the electric drive system.