Blank handgun shots, party balloon bursts, and a pneumatic compressor with a small-diameter nozzle were used as sources of sound in the assessments of reverberation time, T. The two first sources were of impulse type, while the third one resembled a noise signal source. In this work, 532 values of T were experimentally obtained in four rooms of different volumes and compared. The T values for 1/3 octave frequency bands were found to be independent of the sound source. Reverberation times for the A-frequency-weighting filtered signals were close to one another for the shots and balloon bursts, while those obtained using the compressor nozzle were significantly shorter. The latter effect can be attributed to the relatively high share of high frequency waves in the sound generated by the nozzle. The results show that balloon bursts can be used as handgun shot substitutes in the assessments of reverberation times. While the nozzle noise is rather unsuitable for this purpose, it can be applied in the assessments of T for high frequency waves, up to the ultrasound range. Such acoustic climate information may be useful in designing spaces for high frequency sound-sensitive individuals, e.g. animal shelters.

The electrostatic impulse method is an established method for producing microbeads or capsules. Such particles have found application in biomedical engineering and biotechnology. The geometric properties of the droplets – constituting precursors of microbeads and capsules – can be precisely controlled by adjusting the geometry of the nozzle system, the physical properties and the flow rate of the fluids involved, as well as the parameters of the electrostatic impulse. In this work, a method of mathematical modeling of the droplet generation process using the electrostatic impulse method in a single nozzle system is presented. The developed mathematical model is an extension of the standard Volume of Fluid (VOF) model by addition of the effect of the electric field on the fluid flow. The model was implemented into the OpenFOAM toolkit for computational fluid dynamics (CFD). The performed CFD simulation results showed good agreement with experimental data. As a result, the influence of all process parameters on the droplet generation process was studied. The most significant change in droplet generation was caused by changing the electrostatic impulse strength. The presented modeling method can be used for optimization of process design and for studying the mechanisms of droplet generation. It can be extended to describe multi nozzle systems used for one-step microcapsule production.