This work is a contribution to a normative approach of noise assessment in the professional environment. It permits the identification of the affected workstations on the one hand and on the other hand it constitutes an important support to the preoccupations of the impact study on the environment in plants. It also informs us on the adequate preparation of the procedures required by the Environmental Management System (ISO 14001) being implemented in steel-making complex ArcelorMittal Algeria. It constitutes an answer to the recommended environmental politics. The proposed calculation methods are verified according to the recognized sources (ISO 9612, 2009) and the results will be estimated in relation to the legal thresholds recommended by international bodies. The methodology for measuring the noise exposure levels has been done according to the following steps: work analysis; selection of measurement strategy; measurements; error handling and uncertainty evaluations; calculations; and presentation of results. This will lead us to an implementation of a corrective and preventive action plan intended to master this occupational risk carrying prejudice to the health of the workers.

Occupational risk is closely related to work environment. For the same positions, but in different working conditions threats and level of risk can be different. For this also estimating the degree of damage hazard the largest possible should be adopted effects. However, when estimating probability occurrence of threats should include, among others: working conditions, events from the past, or possible employee behavior (in particular those that may be the cause of an accident at work). The source of the above information may be data from statistics or observations of work stations. The article presents the assessment of occupational risk at the position of the laser cutter operator, which was carried out using the Job Safety Analysis (JSA) method. According to this method, occupational risk is determined on the basis of two parameters, i.e.: consequences of C and probability of consequences P. In turn, the probability of consequences is the sum of three factors: frequency of hazard F, probability of event O and avoidability or damage limitation A.

Increased efficiency of production and improved quality have contributed to the development of ultrasonic technological applications, in which low frequency ultrasounds are generated to operate, accelerate as well as to facilitate technological processes. Technological ultrasonic devices (i.e. sources of ultrasonic noise in the work environment, e.g. ultrasonic washers, ultrasonic welding machines) have relatively high power and their nominal frequencies are in the range from 18 kHz to 40 kHz. In Poland, ultrasonic noise (defined as noise containing high audible and low ultrasonic frequencies from 10 kHz to 40 kHz) is included in the list of factors harmful to health in the work environment and therefore the admissible values of ultrasonic noise in the workplaces are established. The admissible values of ultrasonic noise and the new ultrasonic noise measurement method make it possible to perform the assessment of occupational risk related to ultrasonic noise. According to this method, the scope of the measurements includes the determination of the equivalent sound pressure levels in the 1/3 octave bands with the centre frequencies from 10 kHz to 40 kHz. This paper presents the description of both, i.e. the method for ultrasonic noise measurements and the method of the assessment of occupational risk related to ultrasonic noise. The examples of the results of the assessment of occupational risk related to exposure to ultrasonic noise are also discussed.