In this study, ODS ferritic stainless steels were fabricated using a commercial alloy powder, and their microstructures and mechanical properties were studied to develop the advanced structural materials for high temperature service applications. Mechanical alloying and uniaxial hot pressing processes were employed to produce the ODS ferritic stainless steels. It was revealed that oxide particles in the ODS stainless steels were composed of Y-Si-O, Y-Ti-Si-O, and Y-Hf-Si-O complex oxides were observed depending on minor alloying elements, Ti and Hf. The ODS ferritic stainless steel with a Hf addition presented ultra-fine grains with uniform distributions of fine complex oxide particles which located in grains and on the grain boundaries. These favorable microstructures led to superior tensile properties than commercial stainless steel and ODS ferritic steel with Ti addition at elevated temperature.
In this study, to investigate effects of rhenium addition on the microstructures and mechanical properties, 15Cr-1Mo ODS ferritic steels with rhenium additions were fabricated by the mechanical alloying, hot isostatic pressing, and hot rolling processes. Unremarkable differences on grain morphologies and nano-oxide distributions were estimated in the microstructure observations. However, the ODS ferritic steels with 0.5 wt.% rhenium showed higher tensile and creep strengths at elevated temperature than that without rhenium. It was found that rhenium is very effective to improve the mechanical properties.
Ferrtic/martensitic and ODS steels were fabricated by the mechanical alloying process, and their microstructures and mechanical properties were investigated. The 9Cr-1W and 9Cr-1W-0.3Ti-0.35Y2O3 (in wt.%) steels were prepared by the same fabrication process such as mechanical alloying, hot isostatic pressing, and hot rolling processes. A microstructural observation of these steels indicated that the Ti and Y2O3 additions to 9Cr-1W steel were significantly effective to refine the grain size and form nano-sized Y-Ti-O oxide particles. As a result, the tensile strengths at room and elevated temperatures were considerably enhanced. Considerable improvement of the creep resistances at 700°C was also evaluated. It is thus concluded that 9Cr-1W ODS steel with Ti and Y2O3 additions would be very effective in improving the mechanical properties especially at elevated temperatures.