Having increasingly tightened geological and mining conditions in which the extraction of copper ore deposits in Poland is conducted, ensuring effective and safe mining is presently becoming a key task and a significant challenge for mine operators, mainly in the field of ground support systems being the equivalent for the new geological/mining conditions. As one may expect, these conditions shall be characterized by higher values of the primary stress tensor elements as well as the lower deformability and higher strength of the rock mass surrounding the copper ore body. T his means that in the near future, the rock bursts problem will become one of the most important issues deciding on the economy and safety within the newly developed mining areas. T herefore developing a novel effective ductile ground support systems which could be able to control the rock mass movement in squeezing and burst-prone rock conditions is recommended. T his type of requirement may fulfil only ductile or, in other words, the kinetic energy-absorbing systems, which permit slowing down a movement of violently ejected rock blocks. T his paper’s objective is to present the idea of the development of a new type of an effective and low cost ductile resin anchored rockbolt system with smooth and of the square cross-section steel rod is formed in coil shape of different pitch. T he developed bolt prototypes have been tested underground in the G-11 section of the Rudna mine. Results of the pull-out tests, involving different bolts’ shapes and different sliding materials set on the rockbolts’ rods, have proved those bolts’ efficiency as an element of the ductile support system.

The article discusses results of pull-off adhesion strength tests on poly-p- phenylene benzobisoxazole (PBO) mesh bonded to fir timber beams using epoxy resin. The tests were performed in accordance with the PN-EN 1542 standard. Timber elements reinforced with PBO fibres were subjected to pull-off tests to measure the adhesive strength of the mesh to the beams.The factors occurring during the test were also characterized, which may affect its results such as the method of application of the tearing force, selection of epoxy glue, surface preparation of the tested elements, occurrence of material defects in the wood and types of substrate destruction.The experimental data show that failure of the timber layer was not observed in all the specimens tested.