In this paper, the effect of changes the parameters of heat treatment on the structure and the degree of elements segregation was

determined, in the context of corrosion resistance of ductile iron Ni-Mn-Cu, containing 7.2% Ni, 2.6% Mn and 2.4% Cu. In the condition

after casting, castings of austenitic matrix and 160HBW hardness were obtained. The achieved castings were soaked at 450, 550 and

650°C for 4, 8 and 12 hours, then cooled down at the ambient air. In most cases, the heat treatment resulted in a change in the castings

matrix, had the consequence of increasing their hardness in comparison to raw castings. Increasing the temperature and prolonging soaking

time resulted in increasing the degree of transformation of austenite, while reducing the degree of elements segregation. This led to the

formation of slightly bigger number of pitting due to corrosion, but not so deep and more evenly distributed in comparison to raw castings.

Wherein the results of corrosion tests show that heat treatment of castings did not significantly change their corrosion resistance in

comparison to raw castings, in contrast to the significant increase in mechanical properties.

A research of wear resistance of an austenitic cast iron with higher resistance to abrasive-wear and maintained corrosion resistance characteristic for Ni-Resist cast iron is presented. For the examination, structure of raw castings was first formed by proper selection of chemical composition (to make machining possible). Next, a heat treatment was applied (annealing at 550 °C for 4 hours followed by air cooling) in order to increase abrasive-wear resistance. One of the factors deciding intensity of wear appeared to be the chilling degree of castings. However, with respect to unfavourable influence of chilling on machining properties, an important factor increasing abrasivewear resistance is transformation of austenite to acicular ferrite as a result of annealing non-chilled castings. Heat treatment of non-chilled austenitic cast iron (EquNi > 16%) resulted in much higher abrasive-wear resistance in comparison to the alloy having pearlitic matrix at ambient temperature (EquNi 5.4÷6.8%).