Amplitude modulation increases the annoyance caused by wind turbine noise. One gets the improved annoyance when a penalty is added to the measured or calculated time-average sound level. The amplitude modulated wind turbine noise consists of pulses. Each of them could be characterized by the short timeaverage sound level and the modulation depth. The latter determines the pulse penalty. This paper shows how to calculate the improved annoyance of amplitude modulated wind turbine noise, when the short time-average sound level and the penalty for each pulse are known. A special case of identical pulses is discussed. The proposed methodology needs to be tested by research.

Amplitude modulated noise from a single wind turbine is considered. The time-varying modulation depth D_m and the short time-average sound level L_Aeq,τ (with τ = 20 s) are measured at the reference distance d_*. Due to amplitude modulation, a penalty has to be added to L_Aeq,τ. The paper shows how to calculate the corrected long-term time-average sound level L ̂_AeqT (with T >> 20 s), which accounts for amplitude modulation, at any distance d ≠ d_* from the wind turbine. The proposed methodology needs to be tested by research

The specific working conditions of the wind turbine in strong wind cause a number of problems in the measurement of noise indicators used in its short and long-term assessment. The wind is a natural working environment of the turbine, but it also affects the measurement system, moreover, it can be a secondary source of other sounds that interfere with the measurement. One of the effective methods of eliminating the direct impact of wind on the measurement system is placing the microphone on the measurement board at ground level. However, the obtained result can not be directly compared with the admissible values, as it has to be converted to a result at a height of 4 m. The results of previous studies show that this relation depends, inter alia, on the speed and direction of the wind. The paper contains the results of measurements on the measurement board, according to EN 61400-11:2013, and at a height of 4 m above ground made simultaneously in three points around the 2 MW turbine at various instantaneous speeds and changing wind directions. Analysis of the impact of measuring point location on the measurement result of noise indicators and the occurrence of additional features affecting the relationship between the values measured on the board and at the height of 4 m, and especially the tonality, amplitude modulation and content of low frequency content, was m

The paper presents the current state of knowledge concerning the sources of noise generated by wind turbines, force measurement methodology, and assessment of noise onerousness in this type of installation, on the basis of a study concerning a wind farm with five REpower MM92 wind turbines and the electric power of 2 MW and the sound power level of 104.2 dB(A) each. Particular attention was focused on the often discussed problem of presence of infrasound generated by turbines and on the requirements of the applicable reference methodologies for the measurement of wind speed to 5 m/s, while the turbine reaches its full power at speeds above 10 m/s.