This study proposes the LoRa-Based Mesh Sensor Network without relying on LoRaWAN connection sending the communication data in the form of Star-to-Star, it can be sends the data in the form of peer-to-peer without the gateway. In the case that a longer distance is needed, the system is connected by a means of multi-hop presenting the hardware and software model through the use of low voltage power. Then, the testing is done using point to point and the received signal is measured by a gauge and compared with the model in accordance with the theoretical principle.

The article has presented the method of 3D Digital Light Processing printing as one of the technologies used for rapid prototyping of dental models and making elements of dentures. In this work the research was presented, which the aim was to determine the effect of additional exposure time on the properties of the obtained printouts. Dynamic Mechanical Analysis test showed significant differences in stiffness between uncured specimens as well as specimens cured for 10, 20 and 30 minutes. In turn the obtained TG and DTG curves allowed to determine the most optimal curing time for DLP printouts. These studies provide the basis for determining the most appropriate method for handling printouts after the process of printing from liquid resin, so that they are the best possible quality for dentists and prosthodontists.