The Bulletin of the Polish Academy of Sciences: Technical Sciences (Bull.Pol. Ac.: Tech.) is published bimonthly by the Division IV Engineering Sciences of the Polish Academy of Sciences, since the beginning of the existence of the PAS in 1952. The journal is peer‐reviewed and is published both in printed and electronic form. It is established for the publication of original high quality papers from multidisciplinary Engineering sciences with the following topics preferred: Artificial and Computational Intelligence, Biomedical Engineering and Biotechnology, Civil Engineering, Control, Informatics and Robotics, Electronics, Telecommunication and Optoelectronics, Mechanical and Aeronautical Engineering, Thermodynamics, Material Science and Nanotechnology, Power Systems and Power Electronics.

Journal Metrics: JCR Impact Factor 2018: 1.361, 5 Year Impact Factor: 1.323, SCImago Journal Rank (SJR) 2017: 0.319, Source Normalized Impact per Paper (SNIP) 2017: 1.005, CiteScore 2017: 1.27, The Polish Ministry of Science and Higher Education 2017: 25 points.

Abbreviations/Acronym: Journal citation: Bull. Pol. Ac.: Tech., ISO: Bull. Pol. Acad. Sci.-Tech. Sci., JCR Abbrev: B POL ACAD SCI-TECH Acronym in the Editorial System: BPASTS.

Prof. Roman Cieślak from the SWPS University of Social Sciences and Humanities talks about the emotional challenges of pursuing a career in science.

The paper presents the results of research on nanocomposite nickel/graphene oxide (Ni / GO) coatings produced by electrochemical reduction method on a steel substrate. Discussed is the method of manufacturing composite coatings with nickel matrix and embedded graphene oxide flakes. For comparative purposes, the studies also included a nanocrystalline Ni coating without embedded graphene oxide flakes. Graphene oxide was characterized by Raman spectroscopy, infrared spectroscopy (FTIR) and transmission (TEM) and scanning (SEM) electron microscopy. Results of studies on the structure of nickel and composite Ni/GO coatings deposited in a bath containing different amount of graphene oxide are presented. The coatings were characterized by scanning electron microscopy, light microscopy, Raman spectroscopy and X-ray diffraction. The adhesion of the prepared coatings to the substrate was examined by the scratch method. The microhardness of the coatings was measured using the Vickers method on perpendicular cross-sections to the surface. Corrosion tests of the coatings were investigated using the potentiodynamic method. The influence of graphene oxide on the structure and properties of composite coatings deposited from baths with different content of graphene oxide was determined.

Salinity has adverse effects on plants and is one of the causes of environment degradation. Plants have developed many defensive mechanisms, protecting them from sodium chloride (NaCl), including accumulation of osmoprotective compounds, which maintain osmotic balance, protect cell structure and enzymes. In the current study, we investigated the effects of salinity resulting from a range of sodium chloride concentrations (from 0 to 400 mM) on the growth of common duckweed (Lemna minor L.) and yellow lupin (Lupinus luteus L.). Increasing concentration of sodium chloride decreased the area of common duckweed leaves. At the highest applied salt concentration, the decrease of leaf area was associated with leaf chlorosis. In yellow lupin, the increasing sodium chloride concentration inhibited root and stem elongation. The highest tested NaCl concentration of 400 mM completely stopped elongation of yellow lupin shoots. The content of cyclitols and soluble carbohydrates in plant tissues was evaluated as well. Cyclitols (D -chiro -inositol and D -pinitol), as well as soluble carbohydrates (glucose, fructose and sucrose) were detected in common duckweed tissues. Yellow lupin seedlings also contained cyclitols - D -pinitol, myo -inositol and D -chiro -inositol - and soluble carbohydrates - glucose, galactose and sucrose. The content of osmoprotectants in plant tissues, especially sucrose and cyclitols, increased with increasing concentration of sodium chloride in the soil. The results indicate that the content of cyclitols and soluble carbohydrates in plant tissues can be an indicator of plant response to salinity stress.

The main goal of this work is to show the new approach to determining safety technological levels (SLs) in terms of water quality and its chemical stability, as well as issues of water corrosion properties in water distribution systems (WDSs), due to the fact that water supply pipes are prone to corrosion. In the paper the methodology of determining the risk associated with threat to technical infrastructure was considered. The concept was studied on the basis of real operational data from the water treatment plant. The probability of exceeding the individual parameters for WTPI is slightly larger than for WTPII, which means that this water treatment process may cause lack of chemical stability in the water supply network. Operators should anticipate in the process of designing water distribution system, using proper materials, as to ensure an adequate level of safety from the water source to the water recipient. It should be noted that it is necessary to adjust the material of internal installation of water supply networks to the parameters of the water. At present, there are no correlations between the designing step and water parameters. It was concluded that to protect the water supply infrastructure, which belongs to critical infrastructure, water company should put more emphasis on distribution of stable water that has not potentially corrosion properties. Some suggestions were made for the protection of WDS and to ensure safety of system functioning and long-term usability of water pipes.

For over twenty years psychologists have been using information and communication technology to design solutions aimed at improving mental health and quality of life of their clients or patients. One of those solutions are internet interventions. Although these interventions are commonly used in other countries, knowledge about them in Poland is limited. The aim of the article is to introduce to the topic of psychological internet interventions by describing the basic functionalities of internet interventions, the context of their use, their classification, areas where they can be applied and challenges related to their future development and wider implementation.

The article presents research results of the introduction of powdery activated carbon to the existing technological system of the groundwater treatment stations in a laboratory, pilot plant and technical scale. The aim of the research was to reduce the content of organic compounds found in the treated water, which create toxic organic chlorine compounds (THM) after disinfection with chlorine. Nine types of powdery active carbons were tested in laboratory scale. The top two were selected for further study. Pilot plant scale research was carried out for the filter model using CWZ-30 and Norit Sa Super carbon. Reduction of the organic matter in relation to the existing content in the treated water reached about 30%. Research in technical scale using CWZ-30 carbon showed a lesser efficiency with respect to laboratory and pilot-plant scale studies. The organic matter decreased by 15%. Since filtration is the last process before the individual disinfection, an alternative solution is proposed, i.e. the second stage of filtration with a granular activated carbon bed, operating in combined sorption and biodegradation processes. The results of tests carried out in pilot scale were fully satisfactory with the effectiveness of 70–100%.

The work presents experiment results from the area of copper casting technology and chosen examples of alloyed copper. At present,

copper casting technology is applied in many branches of industrial manufacturing, especially in the sector of construction,

communications, arms and power engineering. Alloyed copper, containing slight additions of different elements and having special

physio-chemical properties, is used in a special range of applications. Copper technology and alloyed copper analyses have been presented,

these materials being used for cast manufacturing for power engineering. The quality of casts has been assessed, based on their

microstructure analysis, chemical content and the cast properties. During the research, special deoxidizing and modifying agents were

applied for copper and chosen examples of alloyed copper; also exemplary samples were tested with the help of metallographic analysis,

electrical conductivity and gaseous impurities research.

The effects of gamma irradiation on the vernalization requirements, growth and development of winter wheat grown in a rainout shelter were studied during two successive growing seasons. Dry grains of winter wheat cv. Kobra were irradiated with 300 Gy radiation from a cobalt 60 gamma irradiator. Treated and control grains were pregerminated and subjected to vernalization for 0, 42 or 54 days. Morphological parameters of the plants developing from irradiated seeds (M1 generation) and the plants grown from the seeds produced by the irradiated plants (M2 generation) were measured in order to track the studied effects over two generations. Irradiation of dry grains slowed the growth and development of the plants regardless of the temperature treatment. The measured yield structure elements appeared to be lower for irradiated plants, but no clear effect of radiation on vernalization requirements was noted