Since a few years ago, there is an increasing interest for utilization of transfer functions (TF) as a reliable method for diagnosing of mechanical faults in transformer structure. However, this paper aims to develop the application of TF method in order to evaluate the drying quality of active part during the manufacturing process of transformer. To reach this goal, the required measurements are carried out on 50 MVA 132 KV/33 KV power transformer when active part is placed in the drying chamber. Two different features extracted from the measured TFs are then used as the inputs to artificial neural network (ANN) to give an estimate for required time in drying process. Results show that this new represented method could well forecast the required time. The results obtained from this method are valid for all the transformers which have the same design.

Transformers are one of the most important components of the power system. It is important to maintain and assess the condition. Transformer lifetime depends on the life of its insulation and insulation life is also strongly influenced by moisture in the insulation. Due to importance of this issue, in this paper a new method is introduced for determining the moisture content of the transformer insulation system using dielectric response analysis in the frequency domain based on artificial bee colony algorithm. First, the master curve of dielectric response is modeled. Then, using proposed method the master curve and the measured dielectric response curves are compared. By analyzing the results of the comparison, the moisture content of paper insulation, electrical conductivity of the insulating oil and dielectric model dimensions are determined. Finally, the proposed method is applied to several practical samples to demonstrate its capabilities compared with the well-known conventional method.

As it is found in the related published literatures, the transfer function (TF) evaluation method is the most feasible method for detection of winding mechanical faults in transformers. Therefore, investigation of an accurate method for evaluation of the TFs is very important. This paper presents three new indices to compare the transformer TFs and consequently to detect the winding mechanical faults. These indices are based on estimated rational functions. To develop the method, the necessary measurements are carried out on a 1.3 MVA transformer winding, under intact condition, as well as different fault conditions (axial displacement of winding). The obtained results demonstrate the high potential of proposed method in comparison with two other well-known indices. Additionally, two important methods for describing TFs by rational functions are studied and compared in this paper.