Ice formed on radome surfaces causes communication disruption due to radio-frequency interference (RFI), which reveals the importance of de-icing systems for radomes. As a radome de-icing application, in this work, carbon nanotube (CNT) thin films were fabricated using a spray-coating method, and influence of process parameters on RF transmittance and electrothermal properties was investigated. With the increase of spraying time, sheet resistance of the fabricated film decreases, which results in a decrease of the RF transmittance and improvement of the heating performance. Also, the de-icing capability of the fabricated CNT film was evaluated at –20oC, and efficient removal of ice under cold conditions was demonstrated.

Fusion welding of Ti-Cu is difficult because of big difference of melting points and formation of brittle intermetallic compounds. Friction stir welding is carried out by solid-state joining, thermo-mechanical stirring, and friction heat. Ti-Cu FSW dissimilar welding can supply a very sound joint area with a few intermetallic compounds. Optimized welding process conditions are essential to obtain suitable microstructure and mechanical properties of welded zones. Different welding speeds affect the evolution of microstructure and mechanical properties due to changes of input heat and internal stored deformation energy. The correlation of microstructure and mechanical properties of Ti-Cu welded zone according to welding speeds were investigated and analyzed. As the higher the welding speed, the lower the heat input and the lower the temperature rise. Ti-Cu 75 has the smallest grain size at 13.9 μm, but the optimum mechanical properties and the integrity of welding were shown in Ti-Cu 50.