The transfer function (TF) method is presently a well-known method used to detect various types of winding damage in power transformers. Although abundant research has been done on this subject using laboratory windings as test objects, it is hard to find one, whose test objects are actual large-power transformer windings. Hence, a 400 kV disc winding consisting of 86 discs is used in this paper to study turn-to-turn short circuit with the help of the TF method. To evaluate the effects of this type of fault on TF curves, some mathematical comparison algorithms are used in this research.
This paper describes a fault-tolerant controller (FTC) of induction motor (IM) with inter-turn short circuit in stator phase winding. The fault-tolerant controller is based on the indirect rotor field oriented control (IRFOC) and an observer to estimate the motor states, the amount of turns involved in short circuit and the current in the short circuit. The proposed fault controller switches between the control of the two components of measured stator current in the synchronously rotating reference frame and the control of the two components of estimated current in the case of faulty condition when the estimated current in the short circuit is not destructive of motor winding. This technique is used to eliminate the speed and the rotor flux harmonics and to assure the decoupling between the rotor flux and torque controls. The results of the simulation for controlling the speed and rotor flux of the IM demonstrate the applicability of the proposed FTC.
With the availability of UHV engineering technology, the scale of the power network is expanding, and the level of the short-circuit current is getting higher, which brings hidden trouble to the safe and stable operation of the power network. Further this article issued a method that optimized the configuration of a current limiter based on the reliability of the power network. According to the reliability analysis under the influence of a short circuit, the quantitative evaluation of reliability of the power network is realized by the calculation of the short-circuit current.Aquantitative model is established among reliability evaluation and the short-circuit current as well as load loss, the candidate installation site of a current limiter can be determined according to reliability quantification results. This method uses the particle swarm optimization algorithm to optimize the distribution of the limiter, aiming at the reliability level and the minimum number of current limiters in the short circuit of a power grid. Finally, taking the actual power grid of a province as an example, the result shows that this method can reduce the search space of the optimal solution, optimize the configuration of the current limiter, and effectively limit the short-circuit current and improve the reliability of the power network.
Short-circuit analysis is conducted based on the nodal impedance matrix, which is the inversion of the nodal admittance matrix. If analysis is conducted for sliding faults, then for each fault location four elements of the nodal admittance matrix are subject to changes and the calculation of the admittance matrix inversion needs to be repeated many times. For large-scale networks such an approach is time consuming and unsatisfactory. This paper proves that for each new fault location a new impedance matrix can be found without recalculation of the matrix inversion. It can be found by a simple extension of the initial nodal impedance matrix calculated once for the input model of the network. This paper derives formulas suitable for such an extension and presents a flowchart of the computational method. Numerical tests performed for a test power system confirm the validity and usefulness of the proposed method.
Long transmission lines have to be compensated to enhance the transport of active power. But a wrong design of the compensation may lead to subsynchronous resonances (SSR). For studies often park equivalent circuits are used. The parameters of the models are often determined analytically or by a three-phase short-circuit test. Models with this parameters give good results for frequencies of 50 Hz and 100 Hz resp. 60 Hz and 120 Hz. But SSR occurs at lower frequencies what arises the question of the reliability of the used models. Therefore in this publication a novel method for the determination of Park equivalent circuit parameters is presented. Herein the parameters are determined form time functions of the currents and the electromagnetic moment of the machine calculated by transient finite-element simulations. This parameters are used for network simulations and compared with the finite-element calculations. Compared to the parameters derived by a three-phase short-circuit a significant better accuracy of simulation results can be achieved by the presented method.
en
pl
