The Carpathian Orava Basin is a tectonic structure filled with Neogene and Quaternary deposits superimposed on the collision zone between the ALCAPA and European plates. Tectonic features of the south-eastern margin of the Orava Basin and the adjoining part of the fore-arc Central Carpathian Palaeogene Basin were studied. Field observations of mesoscopic structures, analyses of digital elevation models and geological maps, supplemented with electrical resistivity tomography surveys were performed. Particular attention was paid to joint network analysis. The NE-SW-trending Krowiarki and Hruštinka-Biela Orava sinistral fault zones were recognized as key tectonic features that influenced the Orava Basin development. They constitute the north-eastern part of a larger Mur-Mürz-Žilina fault system that separates the Western Carpathians from the Eastern Alps. The interaction of these sinistral fault zones with the older tectonic structures of the collision zone caused the initiation and further development of the Orava Basin as a strike-slip-related basin. The Krowiarki Fault Zone subdivides areas with a different deformation pattern within the sediments of the Central Carpathian Palaeogene Basin and was active at least from the time of cessation of its sedimentation in the early Miocene. Comparison of structural data with the recent tectonic stress field, earthquake focal mechanisms and GPS measurements allows us to conclude that the Krowiarki Fault Zone shows a stable general pattern of tectonic activity for more than the last 20 myr and is presently still active.
The Szamotuły Graben covers the southernmost part of the Permo-Mesozoic Poznań–Szamotuły Fault Zone. Along this regional discontinuity there are several salt structures, including the Szamotuły diapir, over which an extensional graben formed in the Paleogene and Neogene. The graben is located north of Poznań in central- western Poland, and is NW–SE-trending, ~20 km long, 3–5.5 km wide, and up to 160 m deep. It is filled with Lower Oligocene and Neogene sediments, including relatively thick lignite seams. Data from boreholes allow the assignment of the graben-fill sediments to appropriate lithostratigraphic units. Furthermore, analysis of changes in the thickness of these units provides evidence for periods of accelerated graben subsidence or uplift relative to its flanks. As a result, two distinct stages of tectonic subsidence and one inversion in the Paleogene–Neogene evolution of the Szamotuły Graben have been distinguished. Thus, relatively significant subsidence occurred in the Early Oligocene and the middle Early–earliest Mid-Miocene, while slight inversion took place in the middle part of the Mid-Miocene.
The Silurian Pelplin Formation is a part of a thick, mud-prone distal fill of the Caledonian foredeep, which stretches along the western margin of the East European Craton. The Pelplin Formation consists of organic carbon- rich mudstones that have recently been the target of intensive investigations, as they represent a potential source of shale gas. The Pelplin mudstones host numerous calcite concretions containing authigenic pyrite and barite. Mineralogical and petrographic examination (XRD, optical microscopy, cathodoluminoscopy, SEM-EDS) and stable isotope analyses (δ13Corg, δ13C and δ18O of carbonates, δ34S and δ18O of barite) were carried out in order to understand the diagenetic conditions that led to precipitation of this carbonate-sulfide-sulfate paragenesis and to see if the concretions can enhance the understanding of sedimentary settings in the Baltic and Lublin basins during the Silurian. Barite formed during early diagenesis before and during the concretionary growth due to a deceleration of sedimentation during increased primary productivity. The main stages of concretionary growth took place in yet uncompacted sediments shortly after their deposition in the sulfate reduction zone. This precompactional cementation led to preferential preservation of original sedimentary structures, faunal assemblages and early- diagenetic barite, which have been mostly lost in the surrounding mudstones during burial. These components allowed for the reconstruction of important paleoenvironmental conditions in the Baltic and Lublin basins, such as depth, proximity to the detrital orogenic source and marine primary productivity. Investigation of the concretions also enabled estimation of the magnitude of mechanical compaction of the mudstones and calculation of original sedimentation rates. Moreover, it showed that biogenic methane was produced at an early-diagenetic stage, whereas thermogenic hydrocarbons migrated through the Pelplin Formation during deep burial.
The Family Kumpanophyllidae Fomichev, 1953, synonymised by Hill (1981) with the Family Aulophyllidae Dybowski, 1873, is emended and accepted as valid. The new concept of this family, based on both new collections and discussion on literature data, confirms the solitary growth form of its type genus Kumpanophyllum Fomichev, 1953. However, several fasciculate colonial taxa, so far assigned to various families, may belong to this family as well. The emended genus Kumpanophyllum forms a widely distributed taxon, present in Eastern and Western Europe and in Asia. Its Serpukhovian and Bashkirian occurrences in China vs Bashkirian occurrences in the Donets Basin and in Spain, may suggest its far-Asiatic origin, but none of the existing taxa can be suggested as ancestral for that genus. Thus, the suborder position of the Kumpanophyllidae remains unknown. Four new species: K. columellatum, K. decessum, K. levis, and K. praecox, three Kumpanophyllum species left in open nomenclature and one offsetting specimen, questionably assigned to the genus, are described.
This paper presents the qualitative and quantitative characteristics of microstructures of Neogene clays from Warsaw, Poland. Scanning Electron Microscope (SEM) studies were used for the microstructural analysis of natural clays and clay pastes. Qualitative microstructural changes were observed: from a honeycomb microstructure for the initial clay paste to a turbulent microstructure for the dried paste. It was also noticed that water loss caused by the increase of the suction pressure had a significant impact on the microstructural transformations. Significant changes in the quantitative values of the pore space parameters were also observed. Increase of suction pressure and water loss caused a decrease in porosity and changes in the values of morphometric parameters, such as pore distribution; for example, a significant increase of the number of pores of 0−10 μm size and changes in the geometric parameters of the pore space were noticed with the increase of suction pressure. The pore space with larger isometric pores was modified into a pore space with the dominance of small anisometric and fissure-like pores. The increased degree of anisotropy from a poorly-oriented to a highly-oriented microstructure was also observed. After rapid shrinkage the reduction in the number of pores, maximum pore diameter, and total pore perimeter was recorded. The process of rapid water loss induced the closure of very small pores. A similar effect was observed during the increase of the suction pressure, where the closure of pore space of the clay pastes was observed very clearly.
en
pl
