A method for defects extraction for a mercury cadmium telluride (MCT) multilayer low-bandgap heterostructure is presented. The N⁺/T/p/T/P⁺/n⁺ epitaxial layer was deposited on a GaAs substrate by a metal-organic chemical vapour deposition (MOCVD). The absorber was optimized for a cut-off wavelength of λ_c = 6 μm at 230 K. Deep-level transient spectroscopy (DLTS) measurements were conducted for the isolated junctions of the N⁺/T/p/T/P⁺/n⁺ heterostructure. Three localised point defects were extracted within the p-type active layer. Two of them were identified as electron traps and one as a hole trap, respectively.

The review of peculiarity of growth and experimental results of the magneto-transport measurements (longitudinal magneto-resistance R_xx and the Hall resistance R_xy) over a wide interval of temperatures for several samples of Hg_1−xCd_xTe (x ≈ 0.13–0.15) grown by MBE is presented in this paper. An amazing temperature stability of the SdH-oscillation period and amplitude is observed in the entire temperature interval of measurements up to 50 K. Moreover, the quantum Hall effect (QHE) behaviour of the Hall resistance was shown in the same temperature interval. These peculiarities of the R_xx and R_xy for strained thin layers are interpreted using quantum Hall conductivity (QHC) on topologically protected surface states (TPSS). In the case of not strained layers it is assumed that the QHC on the TPSS contributes also to the conductance of the bulk samples. The experimental results on magneto-transport (QHC and SdH) obtained for the strained 100 nm thickness Hg_1−xCd_xTe layer are interpreted on the basis of the 8 × 8 kp model and an advantage of the Hg_1−xCd_xTe as topological insulators is shown. This article is an expanded version of the scientific reports presented at the International Conference on Semiconductor Nanostructures for Optoelectronics and Biosensors 2016 ICSeNOB2016, May 22–25, 2016, Rzeszow, Poland.

This paper presents examples of infrared detectors with mercury cadmium telluride elaborated at the Institute of Applied Physics, Military University of Technology and VIGO Photonics S.A. Fully doped HgCdTe epilayers were grown with the metal organic chemical vapour deposition technique which provides a wide range of material composition covering the entire infrared range from 1.5 µm to 14 µm. Fundamental issues concerning the design of individual areas of the heterostructure including: the absorber, contacts, and transient layers with respect to their thickness, doping and composition were discussed. An example of determining the gain is also given pointing to the potential application of the obtained devices in avalanche photodiode detectors that can amplify weak optical signals. Selected examples of the analysis of current-voltage and spectral characteristics are shown. Multiple detectors based on a connection in series of small individual structures are also presented as a solution to overcome inherent problems of low resistance of LWIR photodiodes. The HgCdTe detectors were compared with detectors from III-V materials. The detectors based on InAs/InAsSb superlattice materials achieve very comparable parameters and, in some respects, they are even superior to those with mercury cadmium telluride.