The effect of rotating magnetic field on the heat transfer process in a magnetically assisted bioreactor was studied experimentally. Experimental investigations are provided for the explanation of the influence of the rotating magnetic field on natural convection. The heat transfer coefficients and the Nusselt numbers were determined as a function of the product of Grashof and Prandtl dimensionless numbers. Moreover, the comparison of the thermal performance between the tested set-up and a vertical cylinder was carried out. The relative enhancement of heat transfer was characterized by the rate of the relative heat transfer intensification. The study showed that along with the intensity of the magnetic field the heat transfer increased.

The aim of the study was to present an experimental investigation of the influence of the RMF on mixing time. The obtained results suggest that the homogenization time for the tested experimental set-up depending on the frequency of the RMF can be worked out by means of the relationship between the dimensionless mixing time number and the Reynolds number. It was shown that the magnetic field can be applied successfully to mixing liquids.

The main objective of these experiments was to study the oxygen mass transfer rate through the volumetric mass transfer coefficient (kLa) for an experimental set-up equipped with a rotating magnetic field (RMF) generator and various liquids. The experimental results indicated that kLa increased along the magnetic strength and the superficial gas velocity. Mathematical correlations defining the influence of the considered factors on kLa were proposed.

Environmental contamination is an urgent topic to be solved for sustainable society. Among various pollutants, microorganisms are believed to be the most dangerous and difficult to be completely inactivated. In this research, a new hybrid photoreactor assisted with rotating magnetic field (RMF) has been proposed for the efficient removal of two types of bacteria, i.e., gram-negative Escherichia coli and gram-positive Staphylococcus epidermidis. Three selfsynthesized photocatalysts were used, based on commercial titanium(IV) oxide - P25, homogenized and then modified with copper by photodeposition, as follows: 0.5Cu@HomoP25, 2.0Cu@HomoP25 and 5.0Cu@HomoP25 containg 0.5, 2.0 and 5.0 wt% of deposited copper, respectively. The response surface methodology (RSM) was employed to design the experiments and to deteremine the optimal conditions. The effects of various parameters such as copper concentration [% w/w], time [h] and frequency of RMF [Hz] were studied. Results: Analysis of variance (ANOVA), revealed a good agreement between experimental data and proposed quadratic polynomial model ((R2=0.86 for E. coli and R2=0.69 for S. epidermidis). Experimental results showed that with increasing copper concentration, time and decreasing of frequency of RMF removal efficiency was increased. Accordingly, the water disinfection efficiency of 100% in terms of the independent variables was optimized, including cooper concentration c =5 % and 2.5% w/w, time t = 3 h and 1.3 h and frequency of rotating magnetic field f = 50 Hz and 26.6 for E.coli and S. epidermidis, respectively. This study showed that response surface methodology is a useful tool for optimizing the operating parameters for photocatalytic disinfection process.